parts catalog

ADAPTER-TIP 0000232 - Caterpillar

0000232 ADAPTER-TIP Caterpillar parts 385C, 385C FS ADAPTER
Alternative (cross code) number:
Caterpillar 0000232 ADAPTER-TIP

Buy ADAPTER-TIP 0000232 Caterpillar genuine, new aftermarket tractor parts with delivery

Compatible equipment models: 0000232:

FRONT SHOVEL  385C   Caterpillar
Number on catalog scheme: 9F
  For full view, you need register


Illustration 1 g01197962
Schematic for the Lower Anti-Drift SolenoidThis diagnostic code is recorded when the ECM detects a short to ground in the electrical path from the ECM to the solenoid. The possible causes for this diagnostic code are listed:
The internal windings for the solenoid have low impedance.
The internal windings for the solenoid are shorted.
The signal circuit from the ECM to the solenoid is shorted to ground.System Response:The lift linkage will not lower.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear the diagnostic codes when the original diagnostic code is corrected. Note: Ensure that the diagnostic code indicator is active and that the diagnostic code is active.Test Step 1. CHECK THE SOLENOID.
Turn the disconnect switch and the key start switch to the ON position.
Observe the ON/OFF status of the diagnostic code indicator.
Disconnect the solenoid with the diagnostic code from the harness.Expected Result:The diagnostic code indicator remains active.Results:
YES - The diagnostic code indicator remains active and the diagnostic code remains active. The harness has failed or the ECM has failed. Proceed to test step 2.
NO - The diagnostic code indicator is inactive.Repair: The solenoid has failed or the connecting harness has failed. Repeat this test in order to verify the failure. Repair the solenoid or replace the solenoid. Repair the connecting harness or replace the connecting harness at the solenoid. Stop.Test Step 2. CHECK FOR A SHORTED HARNESS.
Turn the disconnect switch to the OFF position.
The solenoid valve from the previous test step remains disconnected.
Disconnect the harness from the implement ECM.
At the harness connector for the ECM, measure the resistance between contact for the failed solenoid circuit J1-61 (wire P945-OR) and contact J1-60 (ground wire J814-BK).Expected Result:The resistance is less than 5000 Ohms.Results:
YES - The resistance is less than 5000 Ohms.Repair: The harness has failed. The corresponding solenoid wire is shorted to ground in the harness. Repair the harness or replace the harness. Stop.
NO - Resistance is greater than 5000 Ohms (no continuity).Repair: The harness circuit resistance is correct. It is unlikely that the ECM has failed. Exit this procedure and perform this troubleshooting procedure again. Also recheck if the diagnostic code indicator is active for this diagnostic code. If the cause is not found, replace the ECM. See Testing and Adjusting, "Electronic Control Module (ECM) - Replace". Stop.

Caterpillar parts catalog:

Caterpillar parts catalog
385C FS Excavator MMA00001-UP (MACHINE) POWERED BY C-18 Engine
385C FS Excavator T2F00001-UP (MACHINE) POWERED BY C18 Engine
385C FS Excavator GLT00001-UP (MACHINE) POWERED BY C18 Engine
385C FS Excavator EAM00001-UP (MACHINE) POWERED BY C-18 Engine

Parts adapter Caterpillar catalog:

374D L, 374F L, 385C, 385C FS, 385C L, 390D, 390D L, 390F L
374D L, 374F L, 385C, 385C FS, 385C L, 390D, 390D L, 390F L
2597729 ADAPTER
325D, 345C, 345C L, 345C MH, 345D L, 365C, 365C L, 385C, 385C FS, 385C L, M325D L MH, M325D MH
2527763 ADAPTER
M325C MH, M325D L MH, M325D MH
2460428 ADAPTER
M325C MH, M325D L MH, M325D MH, M330D
2780934 ADAPTER
365C L MH, 385C L MH
2852994 ADAPTER
365C, 365C L, 365C L MH
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.