parts catalog

ADAPTER 2H9386 - Caterpillar

2H9386 ADAPTER Caterpillar parts ADAPTER
Alternative (cross code) number:
Caterpillar 2H9386 ADAPTER
Weight: 0.07 pounds 0 kg.

Buy ADAPTER 2H9386 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register


Removal Procedure
Start By:
Remove the valve cover. Refer to Disassembly and Assembly, "Valve Mechanism Cover - Remove and Install".Note: Put identification marks on all hoses, on all hose assemblies, on all wires, and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss, and helps to keep contaminants from entering the system.Note: Cleanliness is an important factor. Before you begin the removal procedure, the exterior of the components should be cleaned thoroughly. This will help to prevent dirt from entering the internal mechanism.
Illustration 1 g01265475
Disconnect harness assemblies (3). Remove bolts (1) and nuts (2). Remove valve actuator (4).Installation Procedure
Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Illustration 2 g01265475
Position valve actuator (4). Install bolts (1) and nuts (2). Tighten bolts (1) and nuts (2) to a torque of 100 20 N m (74 15 lb ft). Connect harness assemblies (3).
Adjust the valve actuators. Refer to Testing and Adjusting, "Variable Valve Actuators - Inspect/Adjust" for the proper procedure.End By:
Install the valve cover. Refer to Disassembly and Assembly, "Valve Mechanism Cover - Remove and Install".

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.