AVSPARE.COM
parts catalog

ADAPTER-COND 4647349 - Caterpillar



4647349 ADAPTER-COND Caterpillar parts ADAPTER
Rating:
61
Alternative (cross code) number:
CA4647349
464-7349
4647349
Caterpillar 4647349 ADAPTER-COND

Buy ADAPTER-COND 4647349 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Illustration 1 g01334596
Cat Data Link connectionsThis CID 0588 FMI 14 diagnostic code is associated with the communication between the Machine ECM and the Monitoring System (Messenger) that is conducted on the Cat Data Link circuit.The FMI 14 means that the Machine ECM is communicating with the Messenger on the Cat Data Link circuit, however, the Machine ECM is not receiving expected operating parameter information from the Messenger. The possible causes of the CID 0588 FMI 14 diagnostic code are listed below:
The software that is installed on the Messenger is incorrect.
The software that is installed on the Machine ECM is incorrect.
A new ECM has been installed that is not the correct part.Note: Ensure that the CID 0588 FMI 14 diagnostic code is active before performing this procedure.Test Step 1. VERIFY THE HARDWARE AND THE SOFTWARE PART NUMBERS
Verify that the following information is correct:
The part number of the installed software for the Machine ECM
The part number of the installed software for the Messenger
The part number of the Machine ECM
The part number of the Messenger Note: Contact your dealership's Technical Communicator for the correct part numbers of the hardware and the correct part numbers for the configuration software for your machine. Expected Result:All hardware and software part numbers are correct. Results:
OK - All hardware and software part numbers are correct. Proceed to Test Step 2.
NOT OK - All hardware and software part numbers are NOT correct. Repair: Replace the hardware or software that is incorrect with the correct version. For flashing software, refer to Troubleshooting, "Electronic Control Module (ECM) - Flash Program". For replacing ECM modules, refer to Troubleshooting, "Electronic Control Module (ECM) - Replace"STOPTest Step 2. CHECK THE STATUS OF THE DIAGNOSTIC CODE
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Check the status of the CID 0588 FMI 14 diagnostic code.Expected Result:The CID 0588 FMI 14 diagnostic code is not active. Results:
OK - The CID 0588 FMI 14 diagnostic code is not active. The diagnostic code does not exist at this time. The initial diagnostic code could have been caused by a start up problem with one of the ECM controls. Resume normal operation.STOP
NOT OK - The CID 0588 FMI 14 diagnostic code is active. The diagnostic code has not been corrected.Repair: Repeat this procedure again and verify that the information is correct.If the cause of the problem is not found, the ECM that has activated the diagnostic code may have failed. Prior to replacing an ECM, always contact your dealership's Technical Communicator for possible consultation with Caterpillar. This consultation may greatly reduce repair time. If the cause of the diagnostic code is not found, replace the ECM that has activated the diagnostic code. Refer to Troubleshooting, "Electronic Control Module (ECM) - Replace".STOP


Parts adapter Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.