AVSPARE.COM
parts catalog

ADAPTER, TUBE 7096799C1 - Caterpillar



7096799C1 ADAPTER, TUBE Caterpillar parts ADAPTER
Rating:
81
Alternative (cross code) number:
CA7096799C1
70967-99C1
7096799C1
Caterpillar 7096799C1 ADAPTER, TUBE

Buy ADAPTER, TUBE 7096799C1 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme: 10
 
  For full view, you need register

Information:

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     4C-6486     Stand     1    
8S-7621 Tube     1    
8S-7615 Pin     1    
Personal injury or death can result from improper lifting or blocking.When a hoist or jack is used to lift any part or component, stand clear of the area. Be sure the hoist or jack has the correct capacity to lift a component. Install blocks or stands before performance of any work under a heavy component.Approximate weights of the components are shown. Clean all surfaces where parts are to be installed.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Put identification marks on all hoses and on all tubes for installation purposes. Plug all hoses and all tubes. This helps to prevent fluid loss and this helps to prevent contaminants from entering the system.
Illustration 1 g00928669
Install Tooling (A) on the underside of boom (1) in order to support the boom.
Illustration 2 g00928671
Disconnect two hoses (2) from diverter valve (3) .
Illustration 3 g00928672
Remove bolt (4) and the washer which secures pin (5) to quick coupler (6). Remove the pin out of the quick coupler and cylinder (7) .
Illustration 4 g00928674
Remove bolt (8), the washers and the nut which is used as a lock to retain pin (9) into quick coupler (6) .
Illustration 5 g00928676
Attach two suitable nylon lifting slings around quick coupler (6) and to a suitable hoist. Take up the tension in order to support the quick coupler. The weight of the quick coupler is approximately 122 kg (269 lb).
Remove pin (9) out of the quick coupler and boom head (10). Remove the quick coupler from the machine.


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.