AVSPARE.COM
parts catalog

AXLE GP 3599520 - Caterpillar



3599520 AXLE GP Caterpillar parts AXLE
Rating:
36
Alternative (cross code) number:
CA3599520
359-9520
3599520
Caterpillar 3599520 AXLE GP
Weight: 1543 pounds 699 kg.

Buy AXLE GP 3599520 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Inlet Valves And Seats
Inlet valves and springs should be replaced. If the inlet valve seats show signs of slight nicks or scratches, they can be redressed with a fine piece of emery cloth or by lapping with a lapping stone, grinding compound and grinding tool. If the seats are damaged to the extent that they cannot be reclaimed, they must be replaced. The dimension from the top of the cylinder block to the inlet valve should not exceed .113 in. nor be less than .101 in.Assembly
GENERAL All torques specified in this manual are assembly torques and typically can be expected to fall off after assembly is accomplished. DO NOT RE-TORQUE after initial assembly torques fall.To convert inch pounds of torque to foot pounds of torque, divide inch pounds by 12. To convert foot pounds of torque to inch pounds of torque, multiply foot pounds by 12.foot pounds x 12 = inch poundsInstalling Crankshaft
If the crankshaft is fitted with oil seal rings, install rings. Position ball bearing(s) and crankshaft in crankcase, making certain the drive end of the crankshaft is positioned in the crankcase as marked before disassembly.If one end of the crankcase is counterbored for a ball bearing, make certain the crankshaft is installed through the correct end of the crankcase. Carefully press the crankshaft and bearings into the crankcase.Position a new rear end cover gasket over the rear end of the crankcase, making certain the oil hole in the gasket lines up with the oil hole in the crankcase. Install end cover with oil seal ring (if used) on crankcase. The end cover should be positioned correctly in relation to the oil holes in the gasket and crankcase. Install cap screws with lock washers and torque to 175-225 inch pounds.If the opposite end cover requires an oil seal, the new seal should be pressed into the end cover. Install a new end cover gasket and carefully install end cover over crankshaft and to crankcase to avoid damage to seal. Install cap screws and lock washers and torque to 175-225 inch pounds.Pistons And Connecting Rods
If new wrist pin bushings are to be used (steel rods only) they should be pressed into


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.