AVSPARE.COM
parts catalog

BAFFLE 5088508 - Caterpillar



5088508 BAFFLE Caterpillar parts BAFFLE
Rating:
26
Alternative (cross code) number:
CA5088508
508-8508
5088508
Caterpillar 5088508 BAFFLE

Buy BAFFLE 5088508 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme: 2
 
  For full view, you need register

Information:

Removal Procedure
The ends of the bellows are very sharp. Injury could occur if the bellows are not handled properly. Handle the bellows by the convolutions.
The bellows must be supported at all times when the bellows are not installed in the application. Failure to support the bellows adequately could result in the failure of the bellows. Do not use power tools in order to disassemble or assemble any part of the flexible exhaust system.The alignment of the bellows is important. Incorrect alignment may lead to premature failure of the bellows. Misalignment can be identified by visually inspecting the uniformity of the spacing between the convolutions on the bellows.Inspect the bellows for damage prior to installation. If there is any damage to the convolutions, discard the bellows. If there is any difficulty in installation after the repair, discard the bellows.
Illustration 1 g03350449
The lateral alignment of the bellows is critical. Ensure that the alignment is maintained in Position (A) and Position (B).
Remove the nuts and bolts (3).
Remove gasket (2) (not shown) from between Clean Emission Module (CEM) (1) and flexible exhaust pipe (4).
Remove nuts (5) and bolts (7). Support flexible exhaust pipe (4) as the nut and bolts are removed.
Remove flexible exhaust pipe (4).
Remove gasket (6) (not shown) from the Aftertreatment Regeneration Device (ARD). Assembly Procedure
Ensure that the flexible exhaust pipe assembly is clean and free from wear and damage. If necessary, replace the flexible exhaust pipe assembly as an assembly.
Illustration 2 g03350449
The lateral alignment of the bellows is critical. Ensure that the alignment is maintained in Position (A) and Position (B).
Position a new gasket (6) (not shown) onto the Aftertreatment Regeneration Device (ARD).
Install flexible exhaust pipe (4). Ensure the correct orientation of the flexible exhaust pipe.
Install nuts (5) and bolts (7). Support flexible exhaust pipe (4) as the nut and bolts are installed.
Position a new gasket (2) (not shown) between Clean Emission Module (CEM) (1) and flexible exhaust pipe (4).
Install the nuts and bolts (3) hand tight.
Tighten nuts (5) and bolts (7) to a torque of 25 N m (221 lb in).
Tighten the nuts and bolts (3) to a torque of 25 N m (221 lb in).
Ensure that the alignment is maintained in Position (A) and Position (B) as the nuts and the bolt are tightened.

Caterpillar parts catalog:

Caterpillar parts catalog
573D WHEEL FELLER BUNCHER D7300001-UP (MACHINE) POWERED BY C7.1 ENGINE
2670D WHEEL FELLER BUNCHER D2600001-UP (MACHINE) POWERED BY C7.1 ENGINE


Parts baffle Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.