AVSPARE.COM
parts catalog

BEARING-THRUST 1C4089 - Caterpillar



1C4089 BEARING-THRUST Caterpillar parts BEARING
Rating:
26
Alternative (cross code) number:
CA1C4089
1C-4089
1C4089
Caterpillar 1C4089 BEARING-THRUST
Weight: 0.05 pounds 0 kg.

Buy BEARING-THRUST 1C4089 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Note B: Crankshaft is positioned at top dead center number one on the firing stroke prior to shipping.
Note E: The oil pump drive gear, bolt and washer are not included with the long block. If these parts are needed, they must be ordered separately.
Note F: The customer may need to remove the wheel stud from the front plate assembly. Form SEHS9670 is attached to the wheel stud located on the front plate assembly above the fuel pump drive area.
Note G: The lifting group is for handling during installation and removal from shipping container. The customer may have to use the lifting eyes from their removed engine. Form SEHS9666 is attached to rear eye.
Note H: Installed with seal, bases, and bolts, these valve covers are for debris protection. The customer will have to use the valve cover lids from their removed engine.
Note J: The o-ring used between the water pump inlet adapter and the water pump cover is "SHIPPED LOOSE".
Note K: The customer will use the front support from their removed engine. Form SEHS9667 is attached to front housing in area of front support mounting.
The customer may also need to change the fan drive mounting studs. Form SEHS9668 is attached to a fan drive mounting stud.
The customer may also need to exchange the water pump gear cover with a bracket or cover from their engine. Form SEHS9669 is attached to the water pump gear cover.
Note L: Certain 3406B long blocks may be assembled with 3406C era crankshaft, connecting rods, and pistons. This product improvement requries any future individual cylinder repairs to be made with parts which match the long block, not the original engine's consist. 3406B era parts may be used for a future repair only if they are replaced in matched sets. The pistons and connecting rods must be correct for the crankshaft being used. Different generations of pistons, rods, and cranks can not be mixed. A plate on the long block explains how to look up the correct parts to match the long block in the event of a future repair.
SELD0190 CATERPILLAR? ?2008 Caterpillar


Parts bearing Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.