AVSPARE.COM
parts catalog

BLADE GP-RVSBL 3156676 - Caterpillar



3156676 BLADE GP-RVSBL Caterpillar parts BLADE
Rating:
31
Alternative (cross code) number:
CA3156676
315-6676
3156676
Caterpillar 3156676 BLADE GP-RVSBL

Buy BLADE GP-RVSBL 3156676 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Removal Procedure
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide"for tools and supplies to collect and contain fluids in Caterpillar machines.Dispose of all fluids according to local regulations.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes.
Lower the screed on a hard, flat surface.
Turn the disconnect switch to the OFF position.
Illustration 1 g02476044
Loosen bolts (2) and remove cover (1).
Illustration 2 g02476047
Disconnect harness assemblies (5) and (6). Remove the nut and ground wire (7). Remove the bolts and clamp (4). Move harness assembly (3) out of the way.
Illustration 3 g02476052
Remove the nut, the bolt, and clamp (9). Loosen the screw and disconnect harness assembly (8).
Illustration 4 g02476053
Remove cable straps (11) from the transverse beam. Disconnect harness assembly (10) from the slope sensor on the transverse beam.
Illustration 5 g02476055
Disconnect hose assemblies (12).
Illustration 6 g02476056
Remove bolts (11), the nuts, the washers, and screed (12) from the machine. Installation Procedure
Illustration 7 g02476056
Install screed (14), bolts (13), the washers, and the nuts to the machine.
Illustration 8 g02476055
Connect hose assemblies (12).
Illustration 9 g02476053
Connect harness assembly (10) to the slope sensor on the transverse beam. Install cable straps (11) to the transverse beam.
Illustration 10 g02476052
Connect harness assembly (8) and tighten the screw. Install clamp (9), the bolt, and the nut.
Illustration 11 g02476047
Place harness assembly (3) into position. Install clamp (4) and the bolts. Connect harness assemblies (5) and (6). Install ground wire (7) and the nut.
Illustration 12 g02476044
Install cover (1) and tighten bolts (2).


Parts blade Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.