BLADE AS-LGP 4Z9396 - Caterpillar

936 Loaders
The two louver assemblies by the windshield can be replaced with the new louver assemblies. In each rear corner of the cab, there are two louver assemblies at right angles to each other. In each corner, one new louver assembly and one former louver assembly should be used.
215, 225, 235, 245 Excavators; 950B, 966D, 980C Loaders; 613C, 615, 814B, 824C Tractors; 815B, 816B, 825C, 826C Compactors
The new louver assembly can be used as a direct replacement for the former louver assembly.
D8L, D9L, D10 Tractors
The front louver assembly on the left hand console will not accept the new 7T4306 Louver Assembly without interference. Use a 7G3411 Cover over this opening. The air flow will be sufficient through the remaining 11 vents. The new 7T4306 Louver Assembly can be used in the other 11 openings.
12G, 14G, 16G, 120G, 130G, 140G Motor Graders
The 7T4306 Louver Assembly will interfere with the lamp socket in the left hand console next to the controls. Also, the new louver assembly cannot be used at the two locations at the top of the duct under the windshield. The remaining five openings will accept the new louver assembly with no interference.