BODY AS 1694774 - Caterpillar

Illustration 1 g02775776Note:
Table 1
Specification for 227-6116 Final Drive Gp
Item Qty Part Specification Description
1 16 179-8733 Bolt Use the following procedure to tighten the bolts:
1. Tighten bolts to 420 60 N m (310 44 lb ft).
2. Tighten each bolt for an additional 60 5 degrees.
2 2 096-3216 Socket Setscrew Torque to 105 20 N m (77 15 lb ft).
3 1 199-4503 Cover Before assembly, apply Loctite High Flex GM to the mating surfaces of the cover and the ring gear (4).
5 2 168-8452 Ball Bearing Apply Loctite C5A copper anti seize to the outside diameter and the inside diameter of the mating parts of ball bearings.
6 1 207-1571 Duo-Cone Seal Gp Rubber toric seals and all surfaces in contact with the seals must be clean and dry at assembly. Apply a thin layer of 6V-4876 Lubricant on the surfaces of the metal seals that are in contact just before installation. The metal seal must be assembled square with the bore. The rubber toric seals must not bulge. The rubber toric seals must not be twisted.
7 6 095-0891 Spring Pin After installation of spring pins , create two stake marks for each pin lightly near the hole of spring pins. Refer to Illustration 1 for the locations of the stake marks.
C - - Distance from the edge of the spring pin holes to the stake mark is 2.25 0.75 mm (0.089 0.030 inch).
8 12 9X-6032 Bolt Torque to 60 12 N m (44 9 lb ft).
9 2 3E-2338 Pipe Plug Torque to 80 10 N m (59 7 lb ft).
10 4 8T-0293 Bolt Apply blue Loctite 242 to the threads of bolts. The threads must be cleaned dry before applying the sealant.
11 As required, use the following plates in order to adjust the clearance (D) between 1.0 to 2.0 mm (0.04 to 0.08 inch):
1 094-0578 Plate Thickness is 8.0 0.2 mm (0.31 0.01 inch).
1 094-0579 Plate Thickness is 9.0 0.2 mm (0.35 0.01 inch).
1 094-0580 Plate Thickness is 10.0 0.2 mm (0.39 0.01 inch).
Refer to Disassembly and Assembly, "Final Drive - Assemble" for the procedure to adjust the preload on the ball bearing.