parts catalog

BOLT 0000892 - Caterpillar

0000892 BOLT Caterpillar parts BOLT
Alternative (cross code) number:
Caterpillar 0000892 BOLT

Buy BOLT 0000892 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register


Illustration 1 g01003454
Schematic of the speed sensor for the right trackThis diagnostic code is recorded when the ECM reads speed sensor signal for the right track as having an abnormal frequency. The engine must be running and the lever must be in the FORWARD position or the REVERSE position in order to detect this diagnostic code.The possible causes of this diagnostic code are listed:
The right track has stalled for seven seconds.
The + battery circuit (497-BU) from the electrical system to the sensor is open.
The return circuit (J764-BR) is open.
The signal circuit is open or the sensor is disconnected.
The signal circuit is shorted to a positive voltage source.
The signal circuit is shorted to ground.
The sensor is misaligned or adjusted incorrectly.
The sensor has failed.
The ECM has failed. This is unlikely.System Response:When this diagnostic code occurs, the action lamp is NOT on. The machine will rely on accurate calibration values for straight tracking performance.Note: A diagnostic code will not be logged if both tracks are stalled for seven seconds.Note: Certain procedures can cause diagnostic codes for the speed sensor to occur. A stall condition for one track could trigger a diagnostic code for the speed sensor. Note: Ensure that the diagnostic code for the sensor is on hold and that the diagnostic indicator is ON. This procedure can cause related diagnostic codes to be recorded. Ignore these created diagnostic codes. When the procedure is completed, clear the created diagnostic codes. Test Step 1. CHECK THE RETURN CIRCUIT
Turn the key start switch to the OFF position.
Disconnect the machine harness connector from the sensor.
At the machine harness connector for the sensor, measure the resistance between return circuit J1-70 (J764-BR) and the frame ground.Expected Result:The resistance should measure 5 ohms or less. Results:
OK - The return circuit is correct.

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.