AVSPARE.COM
parts catalog

BOLT 3156519 - Caterpillar



3156519 BOLT Caterpillar parts 303.5C, 304D CR, 305C CR BOLT
Rating:
47
Alternative (cross code) number:
CA3156519
315-6519
3156519
Caterpillar 3156519 BOLT

Buy BOLT 3156519 Caterpillar genuine, new aftermarket tractor parts with delivery
MINI HYD EXCAVATOR,

Compatible equipment models: 3156519:

MINI HYD EXCAVATOR  303.5C   304D CR   305C CR   Caterpillar
Number on catalog scheme: 21
  
  For full view, you need register

Information:


Illustration 1 g01375179
Schematic of the left front drive motor solenoid This diagnostic code is associated with the left front drive motor solenoid solenoid (all wheel drive). The FMI 05 means that the ECM has determined that the current of the solenoid is below normal. The possible causes of this diagnostic code are listed below:
The energize circuit of the solenoid is open.
The return circuit of the solenoid is open.
The solenoid has failed.
The ECM has failed. This is unlikely. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 2293 FMI 05 is active before performing this procedure.Note: The resistance of the solenoid coil should be 8.7 .4 ohms at 25 °C (77.0 °F).System Response:The diagnostic code of CID 2293 FMI 05 will be logged in the internal memory of the ECM of the All Wheel Drive (AWD).The AWD feature will be disabled.Test Step 1. CHECK THE SOLENOID
Turn the disconnect switch and the key start switch to the OFF position.
Disconnect the solenoid from the machine harness.
At the machine harness connector for the solenoid, place a jumper wire from contact 1 (wire 845-OR) to contact 2 (wire E797-WH).
Turn the disconnect switch and turn the key start switch to the ON position. Note: Do not start the engine.
Observe the status of the CID 2293 FMI 05 diagnostic code.Expected Result:The active diagnostic code changes from an "FMI 05" to an "FMI 06" diagnostic code when the jumper wire is installed.Results:
YES - The active diagnostic code changes from an "FMI 05" to an "FMI 06" diagnostic code when the jumper wire is installed. The solenoid has failed.Repair: The solenoid has failed. Repeat this Test Step "CHECK THE SOLENOID" in order to verify the solenoid failure. Replace the solenoid. Verify that the new solenoid corrects the problem.STOP
NO - The CID 2293 FMI 05 diagnostic code remains active. The jumper wire does not affect the status of the diagnostic code. The solenoid is not causing the problem. Proceed to Test Step 2.Test Step 2. CHECK THE CIRCUIT FOR AN OPEN
Turn the key start switch and turn the disconnect switch to the OFF position.
Disconnect the machine harness connector J1 from the AWD Controller.
The jumper wire that was installed in the previous Test Step remains in place.
At the AWD ECM connector J1 of the machine harness, measure the resistance from the contact J1-60 (wire E797-WH) to contact J1-58 (wire 845-OR).Expected Result:The resistance measurement is less than 5 ohms.Results:
OK - The resistance is less than 5 ohms. The circuit is not open in the machine harness. Proceed to Test Step 3.
NOT OK - The resistance is greater than 5000 ohms. The resistance is not correct. There is an open or a bad connection in the machine harness. A resistance that is greater than 5 ohms but less than 5000 ohms could indicate that one

Caterpillar parts catalog:

Caterpillar parts catalog
304D CR Mini Excavator TYK00001-UP (MACHINE) POWERED BY S3Q2 Engine
303.5C CR Mini Hydraulic Excavator DMY00001-UP (MACHINE) POWERED BY S3Q2 Engine
303C CR Mini Hydraulic Excavator BXT00001-UP (MACHINE) POWERED BY S3Q2 Engine
305 C CR Mini Hydraulic Excavator HWJ00001-UP (MACHINE) POWERED BY S4Q2T Engine


Parts bolt Caterpillar catalog:

1184801 BOLT
303.5C, 304C CR, 304D CR, 305C CR, 933, 933C, D3C III, D4C III, D5C III
1184798 BOLT
303.5C, 304C CR, 304D CR, 305C CR, 315B, 933, 933C, D3C III, D4C III, D5C III
2803760 BOLT
303.5C, 304D CR, 305.5D, 305C CR
2706236 BOLT
303.5C, 303.5D, 303C CR, 304C CR, 304D CR, 305.5D, 305D CR, 904B, 904H
2706257 BOLT
303.5C, 303.5D, 303C CR, 304C CR, 304D CR, 305.5D, 305C CR, 305D CR, 904B, 904H
2706233 BOLT
303.5C, 303.5D, 303C CR, 304C CR, 304D CR, 305.5D, 305C CR, 305D CR, 904B, 904H
8T9080 BOLT-SOCKET HEAD
1290T, 1390, 206B, 212B, 2491, 2590, 303.5C, 303.5D, 303.5E, 303C CR, 303E CR, 304D CR, 304E, 306E, 307, 320 L, 320B, 320B FM LL, 320C, 320C FM, 320D, 320D FM, 320D FM RR, 322B L, 322C FM, 323D LN, 32...
2889297 BOLT
303.5C, 303.5D, 303C CR, 304C CR, 304D CR, 305.5D, 305C CR, 305D CR, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 323D L, 323D LN, 323D SA
2828620 BOLT
303.5C, 303.5D, 303C CR, 304C CR, 304D CR, 305.5D, 305C CR, 305D CR
2828619 BOLT
303.5C, 303.5D, 303C CR, 304C CR, 304D CR, 305.5D, 305C CR, 305D CR
2803774 BOLT-SPECIAL
303.5C, 303.5D, 303C CR, 304C CR, 304D CR, 305.5D, 305C CR, 305D CR
2803771 BOLT
303.5C, 303.5D, 303C CR, 304C CR, 304D CR, 305.5D, 305C CR, 305D CR
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.