AVSPARE.COM
parts catalog

BOLT 4644995 - Caterpillar



4644995 BOLT Caterpillar parts BOLT
Rating:
56
Alternative (cross code) number:
CA4644995
464-4995
4644995
Caterpillar 4644995 BOLT
Weight: 109 pounds 49 kg.

Buy BOLT 4644995 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Illustration 1 g01320849
Schematic of the Blade Control Handle BaseThis diagnostic code is associated with the Blade Control Handle Lift Position sensor (Y-axis). The FMI 08 diagnostic means that the ECM has determined that the signal frequency or the signal pulse width is not within the expected range. The sensor is a PWM sensor that operates at a frequency of approximately 500 hertz. The sensor has an operating duty cycle of 5% to 95%. The possible causes of this diagnostic code are listed below:
The sensor has failed.
Intermittent connections or poor connections
Mechanical devices are loose.
The ECM has failed. This is unlikely.Before performing this procedure, inspect the harness connectors that are involved in the circuit. Poor connections can often be the cause of a problem in an electrical circuit. Verify that all connections in the circuit are clean, secure and in good condition. If a problem with a connection is found, correct the problem and verify that this diagnostic code is active before performing this procedure.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear the diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 1078 FMI 08 is active before performing this procedure.Note: Use a Digital Multimeter for the measurements in this procedure. System Response:A level 1 warning will be generated. The feature is disabled.Test Step 1. CHECK FOR POWER AT THE SENSOR.
Do not disconnect the harness connector from the sensor.
At the back of the harness connector for the sensor, insert a 7X-1710 Multimeter Probe along contact 1 (wire 709-OR) for the voltage supply.
At the back of the harness connector for the sensor, insert a 7X-1710 Multimeter Probe along contact 2 (wire J764-BR) for the ground.
Turn the key start switch and the disconnect switch to the ON position.
Measure the voltage from contact 1 (wire 709-OR) to contact 2 (wire J764-BR).Expected Result:The voltage is 10 0.5 DCV.Results:


Parts bolt Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.