AVSPARE.COM
parts catalog

BOLT S1573 - Caterpillar



S1573 BOLT Caterpillar parts 12F BOLT
Rating:
28
Alternative (cross code) number:
CAS1573
S-1573
S1573
Caterpillar S1573 BOLT

Buy BOLT S1573 Caterpillar genuine, new aftermarket tractor parts with delivery
MOTOR GRADER,

You can buy parts: .

$22.95

28 Jun 2021

US: Gahbin USA (7003)
Rear Torque Strut Mount For 2003-2006 Mazda 6 3.0L/2007-2008 MANUAL 3.0L | A6496, EM9221, 9221 - S1573
Allucam Send us a message with the VIN# & Transmission type. We'll find the right parts for you. || 5 Year one time replacement warranty (PARTS ONLY) || Free expedited shipping (ships within 1 business day except holidays) || OE Specification and design || High quality steel and rubber ensures a smooth and quiet ride
$23.18

28 Jun 2021

US: Autopartsman (7006)
S1573 Fits 2003-2006 Mazda 6 3.0L /2007-2008 MANUAL 3.0L Rear Torque Strut Mount | A6496, EM9221, 9221
Omni 5 Send us a message with the VIN# & Transmission type. We'll find the right parts for you. || OE Specification and design || High quality steel and rubber ensures a smooth and quiet ride || 5 Year one time replacement warranty (PARTS ONLY) || Free expedited shipping (ships within 1 business day except holidays)
$22.50

28 Jun 2021

US: Motormount-parts (7008)
ONNURI Rear Torque Strut Mount For 03-06 Mazda 6 3.0L /07-08 MANUAL 3.0L | A6496, EM9221, 9221 - S1573
ONNURI OE Specification and design || Life Time replacement warranty (One time for PARTS ONLY) || Free expedited shipping (ships within 1 business day except holidays) || High quality steel and rubber ensures a smooth and quiet ride || Send us a message with the VIN# & Transmission type. We'll find the right parts for you.
Number on catalog scheme: 3
 
  For full view, you need register

Compatible equipment models: S1573:

MOTOR GRADER  12F   Caterpillar

Information:

Probable Causes
Leaking seals
Fuel injector tip
Fuel transfer pump seal
Cracked cylinder headRecommended Actions
Note: The procedures have been listed in order of probability. Complete the procedures in order.
Table 1
Troubleshooting Test Steps Values Results
1. Leaking Seals
A. Remove the injector from the affected cylinder and visually inspect the injector O-ring seals for damage.
If leakage is found and the O-rings are in good repair, there may be a problem with the injector. Replace the injector. Ensure that the new trim files are installed. Refer to Troubleshooting, "Injector Trim File - Install" for details. Use Caterpillar Electronic Technician (ET) to perform a "Fuel System Verification Test". Refer to Troubleshooting, "Injector Solenoid - Test" for details.
If the leakage is not located, add the appropriate dye to the fuel tanks. Run the engine at high idle for several minutes. Shut down the engine and remove the valve covers. Use a black light to check for traces of dye around each injector.
O-ring seal
Result: The injector O-ring seal is damaged.
Replace the damaged seals. Install the injector onto the engine and confirm that the repair has resolved the problem.
Result: The injector O-ring seal is not damaged.
Proceed to Test Step 2.
2. Fuel Injector Tip
A. Use Cat ET to perform the "Cylinder Cutout Test" in order to identify any cylinders that may be overfueled.
B. A fuel injector tip that is broken or fractured is a possible cause of a cylinder that is being overfueled. If a cylinder is identified by the test, Remove the injector and check the injector tip for damage. Check the fuel injector tip for cracks or breakage.
Injector tip
Result: The fuel injector tip is damaged.
Replace the suspect injector.
Result: The fuel injector tip is not damaged.
Proceed to Test Step 3.
3. Fuel Transfer Pump Seal
A. Check for fuel leakage around the shaft seal for the fuel transfer pump. Ensure that the weep hole is not plugged.
Pump seal
Result: There is fuel leakage around the shaft seal.
Replace the fuel transfer pump.
Result There is not fuel leakage around the shaft seal.
Proceed to Test Step 4.
4. Cracked Cylinder Head
A. Look for signs of damage to the internal passages for the fuel supply to the injectors in the cylinder head. Check for pin hole leaks. Refer to Disassembly and Assembly.
Cracked head
Result The internal passages for the fuel supply to the injectors are damaged.
Repair or replace the cylinder head.
Complete the procedure in the order in which the steps are listed. If the procedure did not correct the issue, contact your Cat dealer Technical Communicator (TC). For further assistance, your TC can confer with the Dealer Solutions Network (DSN).

Caterpillar parts catalog:

Caterpillar parts catalog
NO. 12F MTR. GRADER 89H00901-01537 (MACHINE)
NO. 12F MTR. GRADER 89H01538-UP (MACHINE)


Parts bolt Caterpillar catalog:

9S1366 BOLT
10S, 120B, 120G, 120H, 120H ES, 120H NA, 128, 12F, 12G, 12H, 12H ES, 12H NA, 130G, 135H, 135H NA, 140, 140B, 140G, 140H, 140H ES, 140H NA, 141, 143H, 14E, 14G, 14H, 14H NA, 153, 16, 160G, 160H, 160H E...
1A8537 BOLT
118, 119, 120, 120B, 120G, 120H ES, 120H NA, 12E, 12F, 12G, 12H, 12H ES, 12H NA, 130G, 135H NA, 140, 140B, 140G, 140H, 140H ES, 140H NA, 143H, 14E, 14G, 14H, 14H NA, 160G, 160H, 160H NA, 163H, 163H NA...
3F5108 BOLT-PLOW
120, 120B, 120G, 120H, 120H ES, 120H NA, 12E, 12F, 12G, 12H, 12H ES, 12H NA, 130G, 135H, 135H NA, 140, 140B, 140G, 140H, 140H ES, 140H NA, 140M, 143H, 14E, 14M, 16, 160G, 160H, 160H NA, 160M, 163H, 16...
0S1573 BOLT
10S, 118, 119, 120, 120B, 120G, 120H, 120H ES, 120H NA, 12E, 12F, 12G, 12H, 12H ES, 12H NA, 12K, 130G, 135H, 135H NA, 140, 140B, 140G, 140H, 140H ES, 140H NA, 140K, 140K 2, 143H, 14E, 14G, 14H, 14H NA...
4F3656 BOLT-PLOW
120G, 12F, 12G, 140, 140G, 140H, 140H NA, 14E, 16, 160G, 215, 215B, 215D, 315C, 320C, 322C, 325B L, 416B, 416C, 416D, 420D, 424B, 424B HD, 424D, 426C, 428, 428B, 428C, 428D, 430D, 432D, 436C, 438C, 43...
5K9107 BOLT-LOCKING
120G, 120H, 120H ES, 120H NA, 120K, 120K 2, 12F, 12G, 12H, 12H ES, 12H NA, 12K, 130G, 135H, 135H NA, 140G, 140H, 140H ES, 140H NA, 140K, 140K 2, 143H, 14E, 14G, 14H NA, 153, 16, 160G, 160H, 160H ES, 1...
4F3658 BOLT-PLOW
120G, 120H, 120H ES, 120H NA, 12E, 12F, 12G, 12H, 12H ES, 12H NA, 130G, 135H, 135H NA, 140, 140B, 140G, 140H, 140H ES, 140H NA, 140K, 143H, 14E, 16, 160G, 160H, 160M, 216, 216B, 216B3, 226B, 226B3, 22...
3B4990 BOLT
12F, 14E, 561B, 561C, 583H, 941, 951B, 955C, 955H, 955K, 955L, 977D, 977H, 977K, 977L, 983, D4D, D5, D5B, D5E, D6C, D6D, D6E, D6E SR, D6F SR, D6G, D6G SR, D6G2 LGP, D6G2 XL, D7F, D8H, D8K
6D4957 BOLT
12F, 14E, 16
6D4957 BOLT
12F, 14E, 16
2D8930 BOLT
12E, 12F, 14E
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.