AVSPARE.COM
parts catalog

BOOM GP 3157247 - Caterpillar



3157247 BOOM GP Caterpillar parts BOOM
Rating:
21
Alternative (cross code) number:
CA3157247
315-7247
3157247
Caterpillar 3157247 BOOM GP

Buy BOOM GP 3157247 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Illustration 28 g02568300
Monitor the hydraulic oil temperature on the operator display. Operate the machine until the oil temperature reaches 43 5.6 °C (110 10 °F).
Press home key (11) .
Illustration 29 g02568302
Press down key (12) until "Service" is highlighted on the display screen.
Press OK key (13) .
Illustration 30 g02568305
Press down key (12) until "Calibrations" is highlighted on the display screen.
Press OK key (13) .
Illustration 31 g02574439
Press down key (12) until "Right Conveyor" is highlighted on the display screen.
Press OK key (13) .
Illustration 32 g02574456
Press OK key (13) to begin the calibration.
Illustration 33 g02574458
Illustration 34 g02574463
Move right conveyor switch (14) to the AUTO position.
Illustration 35 g02568459
Squeeze trigger (15), and move propel lever (1) to the FORWARD position.
Press OK key (13) .
Illustration 36 g02574496
Illustration 37 g02574521
Rotate right conveyor speed dial (16) to the MINIMUM position.
Press OK key (13) .
Illustration 38 g02574536
Rotate right conveyor speed dial (16) clockwise until the right conveyor just begins to operate.
Press OK key (13) .
Illustration 39 g02574557
Rotate right conveyor speed dial (16) clockwise until the speed of the right conveyor sprocket shaft reaches 119 15 rpm. Use Tool (A) to measure the speed.Note: If a photo tachometer is unavailable, use a stopwatch to time the movement of the conveyor slats. Adjust conveyor speed until the selected conveyor slat takes 10.5 1.5 seconds to make a full revolution.
Press OK key (13) .
Illustration 40 g02574559
The display should now read "CALIBRATION COMPLETE". Push back key (17) to return to calibration screen.
Push home key (11) to exit the calibration screen.
Move propel lever (1) to the NEUTRAL position.
Move right conveyor switch (14) to the OFF position.
Move throttle control switch (7) to the LOW IDLE position. Hold the switch in this position for less than 1 second.
After the engine reaches low idle, move engine start switch (8) to the OFF position.


Parts boom Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.