AVSPARE.COM
parts catalog

BRACKET AS 1246103 - Caterpillar



1246103 BRACKET AS Caterpillar parts BRACKET
Rating:
36
Alternative (cross code) number:
CA1246103
124-6103
1246103
Caterpillar 1246103 BRACKET AS
Weight: 0.88 pounds 0 kg.

Buy BRACKET AS 1246103 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Lifting Segments
Make sure the lifting cables and other lifting devices are in good condition and have enough strength for the lifting situation involved. Lifting eyes are not to be side loaded during a lifting operation.Consult your Caterpillar dealer for the proper transporting and lifting procedures, size and type of cables and lifting devices.When lifting components, put the swing lock pin lever and the hydraulic activation control lever in LOCKED position to prevent unexpected machine movements.Use guide or tag lines to prevent components from swinging or turning.Always use a signal man and perform machine movement only after getting signals from the signal man.Do not allow anyone under any raised component.Improper lifting or tiedowns can allow load to shift and can cause injury and damage.
Before lifting, be sure to fully retract all hydraulic cylinders. Secure the piston rod to the cylinder tube with a wire rope cable so the piston rod will not slide out during lifting work.
1. Base Machine - Two lifting eyes are provided on the front of the swing frame. Fasten a proper rated wire rope cable [approximately 6 m] (19 ft 8 in) long to each lifting eye with shackle. To access the lifting eye on the rear of the swing frame, remove the center access cover on top of the engine compartment. Fasten a proper rated wire rope cable [approximately 6 m (19 ft 8 in) long] to the lifting eye with a shackle.Using an appropriate lifting device, tension the lifting cables to take up the weight and slowly lift the base machine. 2. Counterweight - Lift the counterweight in accordance with the procedure described in the previous section. 3. Cab - Install two lifting eye bolts (M16xP2) in the corners, 180° apart, on the cab top and fasten proper rated wire rope cables to the lifting eyes with shackles, as shown above. Lift the cab. 4. Stick with bucket cylinder - Use two lifting eyes provided in the brackets on top of the stick. Install shackles through the lifting eyes and fasten proper rated wire rope cables to the shackles, as shown above. Fasten a wire rope cable to the front section of the stick. It is recommended to use a cloth, as shown above, to protect the lifting cable from being damaged by the stick edges. 5. Bucket - Install bucket linkage pin (1) and protective sleeve (2) in the brackets of the bucket. Hold the linkage pin (1) in place with bolts (3) and nut (4), as shown above. Fasten two proper rated wire rope cables to the linkage pin. 6. Boom with stick cylinder - Use two lifting eyes provided in the brackets on top of the boom. Fasten two proper rated wire rope cables to the lifting eyes with shackles and secure the piston rod to the cylinder tube, as shown above. Slowly lift the boom with the stick cylinder as a set. 7. Boom cylinder - Fasten two proper rated wire rope cables to the


Parts bracket Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.