AVSPARE.COM
parts catalog

BRACKET-RH 1247410 - Caterpillar



1247410 BRACKET-RH Caterpillar parts 322 FM L BRACKET
Rating:
33
Alternative (cross code) number:
CA1247410
124-7410
1247410
Caterpillar 1247410 BRACKET-RH
Weight: 5 pounds 2 kg.

Buy BRACKET-RH 1247410 Caterpillar genuine, new aftermarket tractor parts with delivery
EXCAVATOR,

Compatible equipment models: 1247410:

EXCAVATOR  322 FM L   Caterpillar
Number on catalog scheme: 7
 
  For full view, you need register

Information:


Pressurized system: Hot coolant can cause serious burn. To open cap, stop engine, wait until radiator is cool. Then loosen cap slowly to relieve the pressure.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Topping off or mixing Cat ELC with other products that do not meet Caterpillar EC-1 specifications reduces the effectiveness of the coolant and shortens coolant service life.Use only Caterpillar products or commercial products that have passed the Caterpillar EC-1 specification for pre-mixed or concentrate coolants. Use only Extender with Cat ELC.Failure to follow these recommendations can result in shortened cooling system component life.
Reference: For information about the addition of Extender to your cooling system, see Operation and Maintenance Manual, "Cooling System Coolant Extender (ELC) - Add" or consult your Caterpillar dealer.If an Extended Life Coolant was previously used, flush the cooling system with clean water. No other cleaning agents are required. Use the following procedure to change the Extended Life Coolant.The cooling system pressure cap is located under the hood at the rear of the machine.
Illustration 1 g00753186
Slowly loosen the cooling system pressure cap in order to relieve system pressure. The pressure cap is located on top of the radiator tank on the left side of the machine.
Illustration 2 g00753215
Open the drain valve on the bottom of the radiator. The drain valve can be accessed from the left side of the machine. Allow the coolant to drain into a suitable container.
Flush the cooling system with clean water until the draining water is clean. Close the drain valve.
Replace the water temperature regulator.Reference: Refer to Operation and Maintenance Manual, "Cooling System Water Temperature Regulator - Replace" for the correct procedure.
Add the Extended Life Coolant.Reference: Refer to Operation and Maintenance Manual, "Capacities (Refill)" for the refill capacity of the cooling system.
Start the engine. Run the engine without the cooling system pressure cap until the water temperature regulator opens and the coolant level stabilizes.
Illustration 3 g00753224
Maintain the coolant level in the sight gauge on the upper right side of the radiator.
Install the cooling system pressure cap. Stop the engine.

Caterpillar parts catalog:

Caterpillar parts catalog
322L EXCAVATOR 9RL00001-UP (MACHINE) POWERED BY 3116 ENGINE


Parts bracket Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.