4415601 BRACKET Caterpillar parts
Rating:
Alternative (cross code) number:
CA4415601
441-5601
4415601
CA4415601
441-5601
4415601
Weight: 1 pounds 0 kg.
Number on catalog scheme:
15
For full view, you need register
Information:
Status Messages
Messages are displayed in the information area of the display.
Linkage elevation monitor is unavailable or needs ceiling or floor established again.
Table 1
Cat Grade Control Message Problem Solution
Check Machine Dimensions The dimensions that were entered into the Cat Grade Control system is incomplete, or inconsistent with a machine dimension that can be measured by the system. Contact your Caterpillar technical communicator for more information.
Check Linkage Measurements The arm or linkage measurements are inconsistent with the Bucket PSC extension . Verify bucket dimensions and contact your Caterpillar technical communicator for more information.
Check Body Sensor The system cannot communicate with the body angle sensor, or the sensor is out of operating range. Contact your Caterpillar technical communicator for more information.
Check Boom Sensor The system cannot communicate with the boom POT position sensor, or the sensor is out of operating range Contact your Caterpillar technical communicator for more information.
Check Stick Sensor The system cannot communicate with the stick POT position sensor, or the sensor is out of operating range Contact your Caterpillar technical communicator for more information.
Check Bucket Sensor The system cannot communicate with the bucket position PSC sensor, or the sensor is out of operating range. Contact your Caterpillar technical communicator for more information.
Check Tilt Bucket Sensor The system cannot communicate with the bucket tilt sensor. Contact your Caterpillar technical communicator for more information.
New Sensor Cycle Key Off The system has detected a new tilt bucket angle sensor. Turn off the machine, wait a minute, and start machine.
Messages are displayed in the information area of the display.
Linkage elevation monitor is unavailable or needs ceiling or floor established again.
Table 1
Cat Grade Control Message Problem Solution
Check Machine Dimensions The dimensions that were entered into the Cat Grade Control system is incomplete, or inconsistent with a machine dimension that can be measured by the system. Contact your Caterpillar technical communicator for more information.
Check Linkage Measurements The arm or linkage measurements are inconsistent with the Bucket PSC extension . Verify bucket dimensions and contact your Caterpillar technical communicator for more information.
Check Body Sensor The system cannot communicate with the body angle sensor, or the sensor is out of operating range. Contact your Caterpillar technical communicator for more information.
Check Boom Sensor The system cannot communicate with the boom POT position sensor, or the sensor is out of operating range Contact your Caterpillar technical communicator for more information.
Check Stick Sensor The system cannot communicate with the stick POT position sensor, or the sensor is out of operating range Contact your Caterpillar technical communicator for more information.
Check Bucket Sensor The system cannot communicate with the bucket position PSC sensor, or the sensor is out of operating range. Contact your Caterpillar technical communicator for more information.
Check Tilt Bucket Sensor The system cannot communicate with the bucket tilt sensor. Contact your Caterpillar technical communicator for more information.
New Sensor Cycle Key Off The system has detected a new tilt bucket angle sensor. Turn off the machine, wait a minute, and start machine.