4416656 BRACKET Caterpillar parts
Rating:
Alternative (cross code) number:
CA4416656
441-6656
4416656
CA4416656
441-6656
4416656
Weight: 3 pounds 1 kg.
Number on catalog scheme:
1
For full view, you need register
Information:
Removal Procedure
Start By:
Remove the front housing. Note: Refer to Specification UENR0995 "Engine Design" for non-specified engine Torque Values.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g02788686
Remove screws (2) and cover (1).
Illustration 2 g02788689
Remove inner rotor (4) from outer rotor (3). Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 129-1967 White Grease 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
If any part of the engine oil pump is worn or damaged, the complete assembly of the engine oil pump must be replaced.
Ensure that all components of the engine oil pump are clean and free from wear and damage.
Illustration 3 g02788689
Position outer rotor (3) into the pump body. Check the clearance between outer rotor (3) and the pump body.
Install inner rotor (4) into outer rotor (3). Check the clearance between the lobes of outer rotor (3) and inner rotor (4).
Illustration 4 g02788686
Position a strip of Plastigage onto the outer rotor face with Tooling (A). Position cover (1) and install screws (2) and torque. Remove cover (1) and check clearance between the rotor and cover (1).
Position cover (1) and install screws (2). Tighten screws (2) to a torque of 8 to 9 N m (70 to 83 lb in). End By:
Install the front housing.
Start By:
Remove the front housing. Note: Refer to Specification UENR0995 "Engine Design" for non-specified engine Torque Values.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g02788686
Remove screws (2) and cover (1).
Illustration 2 g02788689
Remove inner rotor (4) from outer rotor (3). Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 129-1967 White Grease 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
If any part of the engine oil pump is worn or damaged, the complete assembly of the engine oil pump must be replaced.
Ensure that all components of the engine oil pump are clean and free from wear and damage.
Illustration 3 g02788689
Position outer rotor (3) into the pump body. Check the clearance between outer rotor (3) and the pump body.
Install inner rotor (4) into outer rotor (3). Check the clearance between the lobes of outer rotor (3) and inner rotor (4).
Illustration 4 g02788686
Position a strip of Plastigage onto the outer rotor face with Tooling (A). Position cover (1) and install screws (2) and torque. Remove cover (1) and check clearance between the rotor and cover (1).
Position cover (1) and install screws (2). Tighten screws (2) to a torque of 8 to 9 N m (70 to 83 lb in). End By:
Install the front housing.