BREAKER AS 4645994 - Caterpillar

Which Generate This Code:This diagnostic code is associated with the calibration of the lift valves. The calibration parameters have been corrupted.This error usually occurs after a software update.System Response:When this diagnostic code occurs, the calibration values will be reset to defaults.Test Step 1. CALIBRATE THE VALVE
Start the procedure for the valve calibration. Refer to Systems Operation, Troubleshooting, Testing and Adjusting, "Bank valve - Calibrate"Expected Result:Calibration causes the diagnostic code to become inactive.Results:
OK - Calibration causes the diagnostic code to become inactive.Repair: Return the machine to normal operation.STOP
NOT OK - Calibration has not caused the diagnostic code to become inactive. Perform the calibration again. Proceed to Test Step 2.Test Step 2. RECALIBRATE THE VALVE
Restart the procedure for the valve calibration. Refer to Systems Operation, Troubleshooting, Testing and Adjusting, "Bank valve - Calibrate"Expected Result:Recalibration causes the diagnostic code to become inactive.Results:
OK - Calibration causes the diagnostic code to become inactive.Repair: Return the machine to normal operation.STOP
NOT OK - If the diagnostic code is still active after completing another calibration, proceed to Test Step 3.Test Step 3. REFLASH THE FIRMWARE
Reflash the firmware for the Display. Refer to Systems Operation, Testing and Adjusting, Troubleshooting, "Module - Flash Program"Results:
OK - STOP