AVSPARE.COM
parts catalog

BUCKET AS-GENERAL PURPOSE 2332922 - Caterpillar



2332922 BUCKET AS-GENERAL PURPOSE Caterpillar parts 304.5, 305.5D, 305.5E, 305D CR, 305E BUCKET
Rating:
71
Alternative (cross code) number:
CA2332922
233-2922
2332922
Caterpillar 2332922 BUCKET AS-GENERAL PURPOSE

Buy BUCKET AS-GENERAL PURPOSE 2332922 Caterpillar genuine, new aftermarket tractor parts with delivery
MINI HYD EXCAVATOR,

Compatible equipment models: 2332922:

MINI HYD EXCAVATOR  304.5   305.5D   305.5E   305D CR   305E   Caterpillar
Number on catalog scheme: 4
 
  For full view, you need register

Information:


When working in or around any body of water, around a stream or river, or in conditions of heavy mud, be careful that the swing bearing, the swing drive gear, and the swivel joint do not dip into water, mud, sand, or gravel. If the swing bearing dips into water, mud, sand, or gravel, immediately grease the swing bearing until the used grease leaks from the outer circle of the swing bearing. Failure to carry out this procedure may cause premature wear in the swing bearing.
Illustration 1 g06223764
Depth of water to the center of the track carrier roller.
The following guidelines pertain to travel across water and travel through mud, sand, or gravel.The machine can travel across a river only under the following conditions:
The bed of the river is flat.
The flow of the river is slow.
The machine dips into the water only to the center of the track carrier roller (dimension A).
Do not allow the fan on the engine to contact the water while the machine travels through the water. Do not allow the fan on the engine to contact the water during a swing while the machine is in the water. Damage to the fan may occur if the fan contacts the water.
While you cross the river, carefully confirm the depth of the water with the bucket. Do not move the machine into an area that has a water depth that is greater than Dimension A.The machine may sink gradually on soft ground. Therefore, you should frequently check the height of the undercarriage from ground level and the depth of water on the ground.Check the swing gear by looking through the port for inspection that is on the upper frame. If there is water in the swing gear, contact your Cat dealer for the required maintenance on the swing gear.After you travel through water, carefully clean the machine to remove any salt, sand, or other foreign matter.Procedure for Removing the Machine from Water or Mud
Do not allow the machine to swing from the force of traveling when you use the bucket , the stick, or the boom to assist in travel. If the force from traveling causes the machine to swing, damage may occur to the swing motor and to the swing drive.
Illustration 2 g06222519
You may not be able to move the machine by using the travel controls only. In this case use both the travel control levers/pedals and the stick to pull the machine out of the water or ground.
Illustration 3 g06222525
The machine may slip because of a steep slope. The procedure in Step 1 may not work. In this case, first rotate the upper structure by 180°. Then use both the travel control levers/pedals and the stick to move the machine up the slope.
Illustration 4 g06212337
It may be impossible to travel because the bottom of the frame comes into contact with the ground or the undercarriage is clogged with mud or gravel. In this case, operate the boom and the stick together. Raise the track and rotate the track forward

Caterpillar SIS machinery equipment:

Caterpillar SIS

Caterpillar parts catalog:

Caterpillar parts catalog
304.5 Mini Hydraulic Excavator WAK00001-UP (MACHINE) POWERED BY 3024 Engine
305D Mini Hydraulic Excavator XER00001-UP (MACHINE) POWERED BY S4Q2T Engine
305.5D Mini Excavator FLZ00001-UP (MACHINE) POWERED BY S4Q2T Engine
305.5E Mini Hydraulic Excavator FKY00001-UP (MACHINE)
305E Mini Hydraulic Excavator XFA00001-UP (MACHINE) POWERED BY C2.4 Engine
305E2 CR Mini Hydraulic Excavator DJX00001-UP (MACHINE) POWERED BY C2.4 Engine
305.5E2 CR Mini Hydraulic Excavator EJX00001-UP (MACHINE) POWERED BY C2.4 Engine


Parts bucket Caterpillar catalog:

3031316 BUCKET GP-EXCAVATION
304C CR, 305.5E, 305C CR, 305E
2794295 BUCKET AR-GENERAL PURPOSE
304C CR, 305.5D, 305.5E, 305C CR, 305D CR, 305E
2767371 BUCKET AS-GENERAL PURPOSE
305.5D, 305.5E, 305D CR, 305E
2749022 BUCKET AR-TILTABLE
304C CR, 305.5D, 305.5E, 305C CR, 305D CR, 305E
2759153 BUCKET AS-DITCH CLEANING
304C CR, 305.5D, 305.5E, 305C CR, 305D CR, 305E
3031345 BUCKET AS-HOE
304C CR, 305.5E, 305C CR, 305E, 308E
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.