63000082 BUSHING, REDUCER Caterpillar parts
CB-414, CB-514, CS-431, CS-433
Rating:
Alternative (cross code) number:
CA63000082
6300-0082
63000082
CA63000082
6300-0082
63000082
VIBRATORY COMPACTOR,
Number on catalog scheme:
21
For full view, you need register
Information:
Illustration 1 g01298017
Visually inspect the wear strips through the cutout feature that is provided on top retaining plate (2) and bottom retaining plate (3). If the wear strips are worn close to the moldboard, replace the wear strips.
Remove top retaining plate (2) and bottom retaining plate (3).
Loosen the locknuts on set screws (1).
Start the engine. Sideshift the blade through the entire limit of travel. Measure the clearance between the wear strips and the blade at four equally spaced points. This will allow you to determine the location of the minimum clearance.
Sideshift the blade to the location of the minimum clearance.
Stop the engine.
Tighten the set screws in order to obtain 0.13 to 0.89 mm (0.005 inch to 0.035 inch) clearance between the moldboard rail and the wear strips at the location of minimum clearance.
Tighten the locknuts on the set screws. Refer to Specifications, SENR3130, "Torque Specifications" for the recommended torque.
Install the top retaining plate and install the bottom retaining plate.
Repeat Steps 2 through 10 for the opposite side of the moldboard. Note: Keeping the wear strips adjusted to specifications regularly will prolong life of components.