BUSHING 9W0099 - Caterpillar

Disassembly Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     1P-1863     Retaining Ring Pliers     1    
B     9U-7479     Compressing Tube     1    
C     2P-8312     Retaining Ring Pliers     1    
D     1U-9889     Crossblock     1    
1B-3573 Bolt     2    
8T-4994 Hard Washer     2    
8T-4122 Hard Washer     2    
8T-4223 Hard Washer     2    
6V-8188 Nut     2    
E     1H-3107     Push-Puller Tool Gp     1    
5F-7343 Bearing Puller Gp     1    
F     1P-0510     Driver Gp     1    
G     1P-0520     Driver Gp     1    
H     138-7575     Link Bracket     3    
J     1U-9200     Lever Puller Hoist     1    
K     138-7573     Link Bracket     2    
L     1P-2420     Transmission Repair Stand     1    
M     1P-1861     Retaining Ring Pliers     1    
N     FT-1028     Sleeve Assembly     1    
1P-0520 Driver Gp     1    
P     -     1/2 - 13 by 11 in Threaded Rod     2    
6V-8188 Nut     4    
5F-7344 Puller Block     2    
R     1P-1863     Retaining Ring Pliers As     1    
S     5F-7345     Screw     1    
5F-7344 Puller Block     1    
7S-7786 Puller Leg     2    
5P-4750 Adjustment Screw     1    Start By:
Separate the transmission from the torque converter. Refer to Disassembly and Assembly, "Transmission and Torque Converter - Separate".Note: Cleanliness is an important factor. Before you begin the disassembly procedure, the exterior of the components should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism. Precision components can be damaged by contaminants or by dirt. Perform disassembly procedures on a clean work surface. Keep components covered and protected at all times.Lubricate the seals with the lubricant that is being sealed.Note: Note the orientation of all components for assembly purposes.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01352804
Remove the gasket from the housing. Remove bearing (1) and seal rings (2) .
Illustration 2 g01352806
Use two people in order to remove rotating clutch (3). The weight of rotating clutch (3) is approximately 29