AVSPARE.COM
parts catalog

CABLE AS 2278041 - Caterpillar



2278041 CABLE AS Caterpillar parts CABLE
Rating:
61
Alternative (cross code) number:
CA2278041
227-8041
2278041
Caterpillar 2278041 CABLE AS

Buy CABLE AS 2278041 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Bulldozer Blade Control
FLOAT (1) - Push the lever all the way forward into detent, for FLOAT. The blade will lower to the ground, and move up and down, following the ground contour.The lever will remain in FLOAT until pulled out of detent. The lever will then return to HOLD when released. LOWER (2) - Push the lever forward to lower the blade. The lever will return to HOLD when released. The blade will remain in the position it is in. HOLD (3) - The lever will return to HOLD when released from either RAISE or LOWER. The blade will remain in the position it is in. RAISE (4) - Pull the lever back to raise the blade. Release the lever to stop lifting the blade. The lever will return to HOLD when released.The lever is detented in the full raise position. It will stay in detent and continue raising, until the blade reaches height set by the lift kickout. Then it returns to HOLD.Bulldozer Blade Tilt Control
TILT LEFT (1) - Pull the lever to the left, toward the operator, and the left side of the blade will lower. When the lever is released it will return to the HOLD position. The blade will remain in the position it is in. HOLD (2) - The lever will return to the HOLD position when it is released from either the left or right side tilt positions. The blade will remain in the position it is in. TILT RIGHT (3) - Push the lever to the right, away from the operator, and the right side of the blade will lower. When the lever is released it will return to the HOLD position. The blade will remain in the position it is in.Bulldozer Blade Tip Control
TIP FORWARD (1) - Push the lever forward and the top of the blade will tip forward. When the lever is released it will return to the HOLD position. The blade will remain in the position it is in. HOLD (2) - The lever will return to the HOLD position when it is released from either the forward or back tip positions. The blade will remain in the position it is in. TIP BACK (3) - Pull the lever back and the top of the blade will tip back. When the lever is released it will return to the HOLD position. The blade will remain in the position it is in.


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.