AVSPARE.COM
parts catalog

CABLE AS 3157174 - Caterpillar



3157174 CABLE AS Caterpillar parts CABLE
Rating:
66
Alternative (cross code) number:
CA3157174
315-7174
3157174
Caterpillar 3157174 CABLE AS

Buy CABLE AS 3157174 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


A fault will appear on the display. Press OK key (14) to acknowledge the fault and return the display to the gauge cluster screen.
Use the gauge cluster in the operator display screen to record the speed at which the machine travels in the forward direction.
After the machine has moved 6 m (20 ft), simultaneously release the following switches:
Propel override switch (12) (left track)
Propel override switch (13) (right track)
Move parking brake switch (2) to the ON position.
Illustration 10 g02527417
(A) 6 m (20 ft) String line distance. (B) 127 mm (5 inch) Allowable drift to left. (C) 127 mm (5 inch) Allowable drift to right.
Measure the distance that the machine drifts. The machine may drift to left (B) or the machine may drift to right (C) . The drift cannot exceed the amount specified in Illustration 10.
Establish a 6 m (20 ft) string line to the rear of the machine. The string line should run from the center of one track, parallel with the track.
Move parking brake switch (2) to the OFF position.
Simultaneously move the following switches into the REVERSE position:
Propel override switch (12) (left track)
Propel override switch (13) (right track)
A fault will appear on the display. Press OK key (14) to acknowledge the fault and return the display to the gauge cluster screen.
Use the gauge cluster in the operator display screen to record the speed at which the machine travels in the reverse direction.
After the machine has moved 6 m (20 ft), simultaneously release the following switches:
Propel override switch (12) (left track)
Propel override switch (13) (right track)
Move parking brake switch (2) to the ON position.
Move throttle control switch (7) to the LOW IDLE position. Hold the switch in this position for less than 1 second.
Illustration 11 g02527422
After the engine reaches low idle, move engine start switch (15) to the OFF position.
Illustration 12 g02527423
(D) 6 m (20 ft) String line distance. (E) 127 mm (5 inch) Allowable drift to left. (F) 127 mm (5 inch) Allowable drift to right.
Measure the distance that the machine drifts. The machine may drift to left (E) or the machine may drift to right (F) . The drift cannot exceed the amount specified in Illustration 12.
Table 1
Pump Neutral Adjustment Chart    
Speed Condition    Travels Straight Forward Using Propel Override Switches    Excessive Drift to Left in Forward Using Propel Override Switches    Excessive Drift to Right in Forward Using Propel Override Switches    
Speed Forward and Speed Reverse Within
7.0 m/min (23 ft/min)     No adjustment necessary     Adjust left pump


Parts cable Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.