AVSPARE.COM
parts catalog

CABLE-BULK 4647404 - Caterpillar



4647404 CABLE-BULK Caterpillar parts CABLE
Rating:
21
Alternative (cross code) number:
CA4647404
464-7404
4647404
Caterpillar 4647404 CABLE-BULK

Buy CABLE-BULK 4647404 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Illustration 1 g01334596
Schematic of the Cat Data Link CircuitThis diagnostic code is recorded when the Machine ECM can not communicate properly with the Engine ECM. The Engine ECM does not support one or more of the parameters requested by machine control.The possible causes of this diagnostic code are listed:
The Machine ECM has the incorrect software installed.
The Engine ECM has the incorrect software installed.
Incompatible software may be installed.Test Step 1. CHECK THE MACHINE ECM AND THE ENGINE ECM FOR PROPER SOFTWARE VERSIONS.
Use Caterpillar Electronic Technician (ET) in order to verify that the versions of software are compatible.Expected Result:The proper versions of software are installed on the Engine ECM and the Machine ECM.Results:
YES - The versions of software are compatible. Proceed to Test Step 2.
NO - The proper software is not installed.Repair: Flash the proper software to the appropriate ECM. Cycle the key switch in order to initialize the new software. Ensure that the diagnostic code is no longer active. STOPTest Step 2. RECHECK FOR DIAGNOSTIC CODES.
Ensure that CID 0590 FMI 14 is active.Expected Result:The diagnostic code is inactive. The diagnostic code indicator is inactive. Results:
YES - The diagnostic code indicator and the diagnostic code are inactive.Repair: Clear the diagnostic code.STOP
NO - The diagnostic code is active.Repair: Exit this procedure and perform the diagnostic code procedure again. If the problem persists, the ECM may have failed. Prior to replacing an ECM, always contact your dealership for possible consultation with Caterpillar. This consultation may greatly reduce repair time. See the Troubleshooting, "Electronic Control Module (ECM) - Replace".STOP


Parts cable Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.