parts catalog

CABLE AS 5088992 - Caterpillar

5088992 CABLE AS Caterpillar parts CABLE
Alternative (cross code) number:
Caterpillar 5088992 CABLE AS
Weight: 4 pounds 2 kg.

Buy CABLE AS 5088992 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme: 21
  For full view, you need register


Hole Preparation
1. Use the wall chart to find the correct drill size. Drill the hole that has the damaged threads. The drill depths suggested allow for tap end clearance, countersink, and chamfer of the top. These depths are minimum and should be increased when possible. On thread relieved holes, such as head bolt threads in the cylinder block, depths should be held from the bottom of the counterbore. It is recommended that a magnetic base drill, drill press or radial drill be used when possible, especially with larger diameter holes.2. Countersink the drilled hole using a countersink with an included angle of 120°. Countersinking is not required on thread relieved holes.3. Tap the drilled hole using the tap and depth shown in the chart.Installation Of Coarse Thread Inserts
1. Screw the insert on the installation tool with the tang toward the front. Install the insert on the tool until the tang engages the driving contour of the tool.2. Position the tool and insert squarely over the tapped hole.3. Rotate the tool, exerting slight pressure against the work, until the insert is engaged in the tapped hole. Continue to rotate the tool until the insert is one-fourth to one-half thread below the top surface. On thread relieved holes, install the insert to the depth of the original thread.Installation Of Fine Thread Inserts
1. The tool to install fine thread inserts has two parts, the body and mandrel.2. Remove the mandrel from the body. Place the insert on the mandrel and engage the tang on the driving contour of the mandrel.3. Install the insert and mandrel into the tool body. Rotate the mandrel until two threads of the insert are engaged in the tool body.4. Place the tool squarely against the tapped hole. Rotate the mandrel, while holding the body of the tool with one hand, until the insert is one-fourth to one-half thread below the top surface. On thread relieved holes, install the insert to the original thread depth. Do not hold the tool body tightly against the work surface. Allow the tool to float.Tang Removal
The tang must be removed after the insert is installed to allow the bolt to be engaged to the correct depth.
On .5 inch, M12 and smaller inserts; the tang must be broken off at the notch in the bottom coil. Use a punch or rod that just fits into the assembled insert. Make sure the punch or rod has a square end. Place the punch or rod in the assembled insert until it rests on the tang. Holding the tool squarely, strike the tool sharply with a hammer.
The tang on inserts .562 inch, M14 or larger, the tang must be broken off at the notch in the bottom coil by using a long nose pliers. Bend the tang up and down to break it off at the notch.

Caterpillar parts catalog:

Caterpillar parts catalog
797F Off-Highway Truck LAJ00001-UP (MACHINE) POWERED BY C175-20 Engine

Parts cable Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.