AVSPARE.COM
parts catalog

CAGE A BRG 2H9391 - Caterpillar



2H9391 CAGE A BRG Caterpillar parts CAGE
Rating:
56
Alternative (cross code) number:
CA2H9391
2H-9391
2H9391
Caterpillar 2H9391 CAGE A BRG
Weight: 0.010 pounds 0 kg.

Buy CAGE A BRG 2H9391 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Which Generate This Code:This diagnostic code is associated with the Throttle Position Sensor. The FMI 13 means that the ECM has determined that the sensor is out of calibration. The possible causes of this diagnostic code are listed below:
The ECM has been replaced.
New software has been installed.
The calibration procedure has failed.
The ECM has failed.Note: Ensure that you have repaired any condition that would cause other active diagnostic codes that are related to this sensor. For example, the CID 0091 FMI 03 or FMI 04 are not active when the CID 0091 FMI 13 is active. If the other diagnostic codes are active, troubleshoot those codes first. Then perform this procedure.Note: Ensure that the diagnostic code of CID 0091 FMI 13 is active before performing this procedure.Test Step 1. CHECK THE CALIBRATION
Perform the necessary adjustment and calibration procedures. Refer to the Testing and Adjusting section of the Service Manual for these procedures. Make sure the calibration has successfully completed without warnings.
Observe the status of the CID 0091 FMI 13.Expected Result:The CID 0091 FMI 13 is not active.Results:
OK - The CID 0091 FMI 13 is not active. The calibration corrected the condition that caused the CID 0091 FMI 13. Resume normal operation.STOP
NOT OK - The CID 0091 FMI 13 is still active.Repair: The diagnostic code is still active. Verify that the correct software has been flashed into the ECM, or that the correct ECM is installed on the machine. Then repeat the calibration. If the diagnostic code is still active and the cause of the diagnostic code is not found replace the ECM. It is unlikely that the ECM has failed. Verify that the sensor and associated circuits are correct before you replace the ECM.STOP


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.