AVSPARE.COM
parts catalog

CAP 0005646 - Caterpillar



0005646 CAP Caterpillar parts CAP
Rating:
86
Alternative (cross code) number:
CA0005646
000-5646
0005646
Caterpillar 0005646 CAP
Weight: 0.80 pounds 0 kg.

Buy CAP 0005646 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Removal Procedure
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Drain the hydraulic system oil. Refer to Operation and Maintenance Manual, "Hydraulic System Oil - Change".
Open the access panel on the right side of the machine.
Put identification marks on all tube assemblies, on all hose assemblies, and on all wires for installation purposes. Plug all tube assemblies and all hose assemblies. This helps prevent contamination of the system.
Illustration 1 g00834646
Disconnect control linkages (1) from spools (2) on the bank valve.
Illustration 2 g00834648
Start at the closest hose assembly (3) on the upper row. Disconnect the hose assembly from the adapter and then remove adapter (4) from the bank valve.Note: The lower row of hose assemblies can not be loosened with the adapters in the upper row.
Remove the remaining hose assemblies and the adapters from the upper row on the bank valve.
Illustration 3 g00834649
Note: The adapters on the lower row do not need to be removed.
After the upper row of hose assemblies and the adapters have been removed, then begin at the closest hose assembly (5) on the lower row.
Remove the lower row of hose assemblies from the bank valve.
Illustration 4 g00834650
Remove hose assembly (6) for the test port from the rear of the bank valve.
Illustration 5 g00834651
Remove hose assembly (7) on the rear of the bank valve.
Illustration 6 g00834652
Note: The bracket will be removed with the bank valve.
Remove bolts (8) and remove bank valve (9) from the machine. The weight of bank valve (9) is approximately 27 kg (60 lb).


Parts cap Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.