parts catalog

CARRIER 5088206 - Caterpillar

5088206 CARRIER Caterpillar parts CARRIER
Alternative (cross code) number:
Caterpillar 5088206 CARRIER

Buy CARRIER 5088206 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register


Illustration 1 g01456046
10R-4388 Front Housing
Remove the engine and the torque converter from the machine.
Remove the existing damper, front housing, camshaft drive gear, and cluster idler gear from the engine.
Clean the engine and inspect the engine in order to make sure that the engine does not contain any damaged parts or debris from damaged parts.
Illustration 2 g01456047
(1) Not enough clearance between the gear and the front housing
Illustration 3 g01456049
(2) Gear is sticking out too far from the front housing.
Illustration 4 g01456050
Measure in 3.5 mm (0.1378 inch) from the front housing inside surface
Illustration 5 g01456048
Remove 3.5 mm (0.1378 inch) of material from the inside surface (3) of the front housing.
Conversion to the new wider cam gear and idler gear assembly requires some modifications to the front gear housing. The inside surface of the front housing must be machined. Illustration 5 shows the inside surface of the front housing.
Illustration 6 g01456419
(1) Centerline of the Crankshaft (2) Area of material that needs to be removed from the support (A) 29° (B) 19° (C) 50 mm (2 inch)
Modify the front support bracket for the engine to the dimensions that are shown in Illustration 6. This will make sure that the damper will have enough clearance. Do not flame cut the front engine support. The front engine support must be machined.Note: If the front engine support meets the dimensions in Illustration 6 then proceed to Step 6.Note: The 105-9083 Engine Support Gp requires some modifications.Note: The 7E-6385 Engine Support Gp does not require any modifications.
Install new 195-0318 Camshaft Gear onto the camshaft. Refer to the engines Disassembly and Assembly Manual for the proper instructions.Note: The preferred method of installing the cam gear is by pressing the cam gear onto the camshaft without the use of heat. Heat may be used if the process is performed properly.Note: Do not heat the cam gear with a torch. Do not heat the cam gear to a temperature that is greater than 205 °C (400 °F) for more than one hour.
Install the new 195-0316 Gear As .
Install the camshaft assembly into the engine.
Install the front housing, modified engine support, 167-8130 Damper, 6N-6037 Damper Adapter, 6N-7654 Spacer, and the required pulley assembly.

Parts carrier Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.