AVSPARE.COM
parts catalog

CHART-DUTY 1246632 - Caterpillar



1246632 CHART-DUTY Caterpillar parts TH63, TH82 CHART
Rating:
8
Alternative (cross code) number:
CA1246632
124-6632
1246632
Caterpillar 1246632 CHART-DUTY
Weight: 0.01 pounds 0 kg.

Buy CHART-DUTY 1246632 Caterpillar genuine, new aftermarket tractor parts with delivery
TELEHANDLER,

Compatible equipment models: 1246632:

TELEHANDLER  TH63   TH82   Caterpillar
  For full view, you need register

Information:


Illustration 1 g02139267
The "Hydraulic Pump 2 Outlet Pressure" sensor is located on the right side of the machine. The sensor is located in the pump compartment.
Illustration 2 g02038058
Schematic of the "Hydraulic Pump 2 Outlet Pressure" SensorThis diagnostic code is associated with the "Hydraulic Pump 2 Outlet Pressure" Sensor. This diagnostic code is recorded when the Machine ECM reads the frequency of the signal and the frequency is not within an expected range. Note: Before performing the following procedure, ensure that the diagnostic code for this procedure is active.The possible causes of this diagnostic code are listed below:
The sensor has failed.
Intermittent connections or poor connections Test Step 1. CHECK THE +8 DCV SUPPLY VOLTAGE.
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness connector from the sensor.
Turn the disconnect switch and the key start switch to the ON position.
At the machine harness connector for the sensor, measure the voltage (DCV) between contact 1 (wire J850-WH) and contact 2 (wire 235-BK).
At the machine harness connector for the sensor, measure the voltage (DCV) between contact 1 (wire J850-WH) and frame ground. Expected Result:The voltage is 8 0.5 DCV for both measurements. Results:
OK - The voltage is 8 0.5 DCV for both measurements. The voltage is correct. Proceed to Test Step 2.
NOT OK - The voltage is NOT 8 0.5 DCV for both measurements. The voltage is not correct. The Machine ECM has failed or the harness has failed. Repair: A failure of the ECM is unlikely. Verify the harness. If the harness is correct, replace the Machine ECM. STOPTest Step 2. VERIFY THE GROUND OF THE SENSOR.
At the machine harness connector of the sensor, place a jumper between contact 2 (wire 235-BK) and frame ground.
At the machine harness connector J1, measure the resistance between the contact J1-14 (wire 235-BK) and frame ground.
At the machine harness connector J1, measure the resistance between the contact J1-2 (wire 235-BK) and frame ground. Expected Result:The resistance is less than 5 ohms for each circuit. Results:
OK - The resistance is less than 5 ohms. The circuit resistance is correct. Proceed to Test Step 3.
NOT OK - The resistance is greater than 5 ohms. The circuit resistance is not correct. The harness is open. Repair: Repair the machine harness or replace the machine harness.STOPTest Step 3. CHECK THE SENSOR SIGNAL CIRCUIT.
Remove the jumper that was placed in the previous test.
At the machine harness connector of the sensor, place a jumper between contact 3 (wire T967-YL) and frame ground.
At the machine harness connector J1, measure the resistance between contact J1-54 (wire T967-YL) and frame ground. Expected Result:The resistance is less than 5 ohms. Results:
OK - The resistance is less than 5 ohms. The circuit resistance is correct. Proceed to Test Step 4.
NOT OK - The resistance is greater than 5 ohms. The circuit resistance is not correct. The harness is open. Repair: Repair the machine harness or replace the machine harness.STOPTest Step 4. CHECK THE MACHINE HARNESS FOR A SHORT TO

Caterpillar parts catalog:

Caterpillar parts catalog
TH63, TH82 and TH83 Telehandler 3JN00001-01509 (MACHINE) POWERED BY 3054 Engine
TH63 Telehandler 3NN00001-UP (MACHINE) POWERED BY 3054 Engine


Parts chart Caterpillar catalog:

1292204 CHART-DUTY
TH103, TH62, TH63, TH82, TH83
1292206 CHART-DUTY
TH103, TH62, TH63, TH82, TH83
1292209 CHART-DUTY
TH103, TH62, TH63, TH82, TH83
1292211 CHART-DUTY
TH103, TH62, TH63, TH82, TH83
1292212 CHART-DUTY
TH103, TH62, TH63, TH82, TH83
1292213 CHART-DUTY
TH103, TH62, TH63, TH82, TH83
1292214 CHART-DUTY
TH103, TH62, TH63, TH82, TH83
1292215 CHART-DUTY
TH62, TH63, TH82
1479542 CHART-DUTY
TH103, TH82, TH83
1246637 CHART-DUTY
TH103, TH62, TH63, TH82, TH83
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.