CLAMP-HOSE 1246267 - Caterpillar

(5ZL, 7TJ),
5130B (4CS),
5230 (7LL) Excavators;
769D (5TR),
771D (6JR),
773D (7ER),
775D (6KR),
785B (6HK),
789B (7EK),
793B (1HL),
793C (4AR) Trucks;
784B (5RK) Tractor;
992G (7HR),
994 (9YF) Wheel LoadersReference: Service Manual Module, SENR6059-03, "Vital Information Management System (VIMS)"VIMS-PC Version 2.2 Software Upgrade is a ".MST" file update and contains the following changes:
Off Highway Trucks:
"D"-series trucks support added.
* New channels were added: Hi and Lo boost pressure. * Parameter names changed to be more uniform.* Events were added/changed.* Changed unit of measure for ground speed from (MPH) to (KPH). Mass Excavators:
* Reinstalled master channel number 530 omitted from V2.1.* Events were changed/added.* Events names changed to be more uniform.* Events were added/changed.* Change to histograms.* Added travel time cumulative.* Parameter names changed to be more uniform.* Events were changed.* Events name change to be more uniform. Large Wheel Loaders:
* Events were changed/removed.* Events names changed to be more uniform.* Change to histogram for Hydraulic Oil Temperature.* Change to long-term cumulative for "Total Fuel Used and Total Fuel Used Idling" from U.S. gallons to liters.* Events were added/changed/removed.* Changes to histogram: For Hydraulic Oil Temperature and Rt/Lt Exhaust Temperature added. Upgrade (9.3X) must be installed on the 994 (9YF) Wheel Loaders before upgrading to VIMS-PC version 2.2. Improvements To VIMS-PC That Will Be Addressed In A Future Upgrade:
* VIMS-PC may not allow "Analysis" to open. Suggest CSS (Caterpillar Common Services Software) be reinstalled to fix problem.* Data Logger and event recorder download conversion error. Try the following procedures if this problem is encountered:1. Download into C:/bs/VIMSDATA only. Do not download into a dedicated sub directory. After the download is complete, use File Manager to move these files out of VIMSData if they are to be stored elsewhere.2. Remove all references in Utilities for the machine that will not allow the data logger and/or events recorder to download. Reconnect the service tool to the machine and try the download.3. Try a different service tool.4. Try a reinstall of VIMS-PC on the service tool that will not download.* A configuration downloaded from a machine may not show complete configuration part number.* In view real time, some parameters are displayed twice.* Cannot download to drive A:.* Erratic operation of status bar during download. Status bar may sometimes indicate 0% download status until approximately 95% of download is complete and then status bar displays 95% and begins to update normally.* During a "data download", the status screen may show "download failed" for a file (like Datalogger) that has no data. In reality, the download for that file is not "failed". The correct error message should be "no data". A 6k "empty" file for the Datalogger is created every time this occurs.This empty should be deleted.* In communication the serial/unit number and date/time /SMH screens each have two hot buttons, "Cancel" and "Ok". "Ok" does nothing and "Cancel" accepts.* In communicate preference, set "Attempts To Communicate" to at least five.* Trends print correctly on the first page but the following pages may be shifted up and left.* On the .ecl, diagnostic limits