AVSPARE.COM
parts catalog

CONFIGURATION 3534335 - Caterpillar



3534335 CONFIGURATION Caterpillar parts CONFIGURATION
Rating:
11
Alternative (cross code) number:
CA3534335
353-4335
3534335
Caterpillar 3534335 CONFIGURATION

Buy CONFIGURATION 3534335 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Introduction
This Special Instruction is organized into modules. Caterpillar suggests installing one module at a time. Install the lines for the stick first. Install the lines for the boom next. Install the control groups last.Note: Drain the hydraulic fluid from the hydraulic tank before opening the hydraulic system. Remember to fill the hydraulic tank with hydraulic fluid once the installation is complete.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before operating any compartment or disassembling any component containing fluids.After collecting all fluids in suitable containers, dispose of all fluids according to local regulations and mandates.
329D2 Field Installed Auxiliary Control Arrangement Hydraulics
1. Install the stick lines for your machine.
Determine the length of the stick in order to select the primary auxiliary lines group.
Determine the rotate lines, and the drain lines.2. Install the boom lines for your machine.
All attachments will require the Primary Auxiliary lines Group. Rotate is only required if a tool that requires a rotate function is installed.Note: Lines are stacked on top of each other so rotate lines cannot be installed without installing the primary auxiliary lines group first.3. Install the selected control group.
Select one control group or column depending on the tools you will be installing. Only one can be installed on a machine.
Table 1
484-9162 Auxiliary Control Arrangement Revision-00    
200-3365 Auxiliary Pump and Mounting Gp
Special Instruction, GEBB1111    
255-1766 Front Lines Gp
Special Instruction, GEBB1114    
416-5027 Pump Lines Gp
Special Instruction, GEHS1117    
416-5028 Pilot Lines Gp
Special Instruction, GEHS1118    
418-1811 Chassis Wiring Gp
Special Instruction, GEHS1119    
288-7022 Film    4. Install the connector lines group.
The connector lines make the final connection to the tool. Connector lines are specific to the work tool.5. Set the machine tool control system.
ReferenceExcavator Tool Control System, KENR9976, "Testing and Adjusting Section", "Machine Tool Control System - Select"6. Set tool flows and pressures.
ReferenceExcavator Tool Control System, KENR9976, "Testing and Adjusting Section", "Process for Setting Up the Work Tool"Principles of Operation
ReferenceExcavator Tool Control System, KENR9976, "Systems Operation Section", "System 11: Combined Function"ReferenceExcavator Tool Control System, KENR9976, "Systems Operation Section", "Medium Pressure Hydraulic System"Serial Number Identification
Caterpillar Work Tools hydraulic kits are identified with serial numbers. The serial number is printed on a film group (1). This film group should be placed on the right-hand window inside the cab.
Illustration 1 g03374483
Illustration 2 g03374485


Parts configuration Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.