AVSPARE.COM
parts catalog

CONSOLE 1C4007 - Caterpillar



1C4007 CONSOLE Caterpillar parts PR-450 CONSOLE
Rating:
57
Alternative (cross code) number:
CA1C4007
1C-4007
1C4007
Caterpillar 1C4007 CONSOLE
Weight: 309 pounds 140 kg.

Buy CONSOLE 1C4007 Caterpillar genuine, new aftermarket tractor parts with delivery
COLD PLANER,

Compatible equipment models: 1C4007:

COLD PLANER  PR-450   Caterpillar
Number on catalog scheme: 10
 
  For full view, you need register

Information:


Table 2
Hydraulic Oil Temperature Sensor Resistance
C° Temperature F° Temperature Resistance
-20 -4 9716
0 32 3268
20 68 1250
50 122 360
100 212 68 The following table is a reference that can be used when checking for proper resistance on the fuel level sensor.
Table 3
Fuel Level Sensor Resistance
Float Position Resistance (Ω)
Full 7.5 to 9
3/4 21
1/2 33.8
1/4 53
Empty 82 to 85 Diagnostic Trouble Code Procedure
Prior to beginning this procedure, inspect the harness connectors that are involved in the circuit. Poor connections can often be the cause of a problem in an electrical circuit. Verify that all connections in the circuit are clean, secure and in good condition. If a problem with a connection is found, correct the problem and verify that this diagnostic code is active before performing this procedure.
Identify the active FMI code associated with the components.
Determine which code is present and use the list below to determine which procedure to follow.
FMI 3 diagnostic code, proceed to Table 4.
FMI 4 diagnostic code, proceed to Table 5.
Table 4
FMI 3 Troubleshooting
Troubleshooting Test Steps Values Results
1. Check The Sensor
Note: Refer to the tables above for a list of resistance values related to specific values.
A. Turn the key start switch and the disconnect switch to the OFF position.
B. Disconnect the sensor from the harness.
C. Measure the resistance between pin 1 and 2 of the sensor.
The resistance reading agrees with the values from the table. OK - The resistance readings agree with the values in the table.
Proceed to Test Step 2.
NOT OK - The resistance readings do not agree with the values in the table.
Repair: Replace the sensor.
Proceed to Test Step 4.
2. Check For An Open In The Sensor Circuit
A. The key start switch and disconnect switch remain in the OFF position.
B. The harness connector remains disconnected from the sensor.
C. At the sensor harness connector, install a jumper wire across pins 1 and 2.
D. Disconnect the J1 and J2 connectors from the ECM.
E. At the ECM harness connector, measure the resistance between the signal and return contacts for the sensor.
The resistance reading is less than 5 Ω. OK - The resistance is less than 5 Ω.
Proceed to Test Step 3.
NOT OK - The resistance is greater than 5 Ω. The open is in the signal circuit or the return circuit.
Repair: Repair or replace the harness.
Proceed to Test Step 4.
3. Check The Signal Circuit For A Short.
A. The disconnect switch and the key start switch remain in the OFF position.
B. The harness connectors J1 and J2 remain disconnected from the ECM.
C. Remove the jumper wire from the sensor harness connector.
D. At the ECM harness connectors, measure the resistance between the signal circuit and all the other contacts that are used on the ECM.
Each resistance reading is greater than 5K Ω. OK - Each measurement is greater than 5K Ω.
Proceed to Test Step 4.
NOT OK - A resistance measurement is less than 5 Ω. A short exists between the signal circuit and the circuit with the low resistance measurement.
Repair: Repair or replace the machine harness.
Proceed to Test Step 4.
4.

Caterpillar parts catalog:

Caterpillar parts catalog
PR-450 COLD PLANER 7DC00204-UP (MACHINE) POWERED BY 3408 ENGINE


Parts console Caterpillar catalog:

2120480 CONSOLE
AD30, AD45B, AD55, AD55B, AD60
2120479 CONSOLE
AD55, AD55B, AD60
1735941 CONSOLE AS
5130B, 5230, 5230B
0820768 CONSOLE
PR-1000, PR-750B
9N7300 CONSOLE
PR-1000, PR-750B
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.