3843594 CONT GP- Caterpillar parts
Rating:
Alternative (cross code) number:
CA3843594
384-3594
3843594
CA3843594
384-3594
3843594
Number on catalog scheme:
For full view, you need register
Information:
Failure of the Normal Power Source
When the voltage of the normal power source falls below the preset dropout voltage, the engine start timer begins. The factory setting for the engine start timer is three seconds. None of the LED indicators will be illuminated. If the voltage of the normal power source remains below the dropout value throughout the cycle of the engine start timer, a signal will be sent in order to start the generator. The "NORMAL POSITION" LED and the "EMERGENCY AVAILABLE" LED will be illuminated. The MX100 controller will then monitor the voltage of the generator and the frequency of the generator. When the voltage and frequency of the generator reach acceptable levels, the delay to EMERGENCY timer begins. The "DELAY TO EMERGENCY" LED will be illuminated.When the delay to EMERGENCY timer completes the cycle, the "DELAY TO EMERGENCY" LED will no longer be illuminated. The transfer to the emergency power source is then completed in the following manner. For the CTG models, the ATS transfers the load to the EMERGENCY position. Power is delivered to the load by the generator. The "EMERGENCY POSITION" LED will become illuminated and the "NORMAL POSITION" LED will no longer be illuminated. If the A6 or T3/W3 options
When the voltage of the normal power source falls below the preset dropout voltage, the engine start timer begins. The factory setting for the engine start timer is three seconds. None of the LED indicators will be illuminated. If the voltage of the normal power source remains below the dropout value throughout the cycle of the engine start timer, a signal will be sent in order to start the generator. The "NORMAL POSITION" LED and the "EMERGENCY AVAILABLE" LED will be illuminated. The MX100 controller will then monitor the voltage of the generator and the frequency of the generator. When the voltage and frequency of the generator reach acceptable levels, the delay to EMERGENCY timer begins. The "DELAY TO EMERGENCY" LED will be illuminated.When the delay to EMERGENCY timer completes the cycle, the "DELAY TO EMERGENCY" LED will no longer be illuminated. The transfer to the emergency power source is then completed in the following manner. For the CTG models, the ATS transfers the load to the EMERGENCY position. Power is delivered to the load by the generator. The "EMERGENCY POSITION" LED will become illuminated and the "NORMAL POSITION" LED will no longer be illuminated. If the A6 or T3/W3 options