AVSPARE.COM
parts catalog

CONTACTOR 7B0158 - Caterpillar



7B0158 CONTACTOR Caterpillar parts D315, D337, D342, D342C, D353C, D364, D375D, D397D CONTACTOR
Rating:
78
Alternative (cross code) number:
CA7B0158
7B-0158
7B0158
Caterpillar 7B0158 CONTACTOR

Buy CONTACTOR 7B0158 Caterpillar genuine, new aftermarket tractor parts with delivery
INDUSTRIAL ENGINE, MARINE ENGINE,

Compatible equipment models: 7B0158:

INDUSTRIAL ENGINE  D342   D342C   D353C  
MARINE ENGINE  D315   D337   D342   D364   D375D   D397D   Caterpillar
Number on catalog scheme: None
 
  For full view, you need register

Information:

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 371-1079 Lifting Plate 1
6V-3940 Bolt 4
6V-8550 Bolt 2 Start By:
Remove the rocker shaft and pushrods.
Remove the exhaust manifold.
Remove accumulator (fuel injection)
Remove the electronic unit injector.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Inspect all O-rings, seals, and gaskets for wear and damage. Replace if necessary.
Drain the coolant from the cooling system into a suitable container for storage or for disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".
Illustration 1 g06331434
Remove two bolts (1) and cover (2).
Illustration 2 g06331747
Remove six bolts (3) from cylinder head (4).
Illustration 3 g06331790Note: Do not use spacers of any kind. Tooling (A) should sit flat on the cylinder head surface.
Attach Tooling (A) and a suitable lifting device to cylinder head (4). Cylinder head (4) weighs approximately 72 kg (160 lb).
Remove cylinder head (4) and position onto suitable cribbing to prevent damage.Note: Exercise care in removing cylinder head (4) and gasket (5) to avoid contamination of the oil supply holes in the cylinder block.
Illustration 4 g06331972
Remove dowel assembly (6) and seal (5).
Remove fire ring (7).
Two positioning dowels (8) must remain in the cylinder block. Insure that positioning dowels (8) are in place before installing cylinder head (4).

Caterpillar parts catalog:

Caterpillar parts catalog
D315 MARINE ENGINE 05V00001-UP
D364 MARINE ENGINE 20B00056-00102
D337 MARINE ENGINE 23B00300-00455
D342 ENGINE 31B00001-02477
D375 MARINE ENGINE 44B00001-UP
D397 MARINE ENGINE 42B00001-UP
D397 MARINE ENGINE 42B00368-00458
D353 ENGINE 46B00001-00598
D353 ENGINE 46B00599-00808
D353 ENGINE 46B00001-00598
D353 ENGINE 46B00599-00808
D342 MARINE ENGINE 32B00001-01539
D342 MARINE ENGINE 32B01540-UP
D397 MARINE ENGINE 42B00368-00458
D375 MARINE ENGINE 44B00613-UP
D342 ENGINE 49B00001-01090
D342 & G342 ENGINE 31B02478-03984


Parts contactor Caterpillar catalog:

9F7837 CONTACTOR (Oil Pressure)
3304, 3306, D320A, D326F, D334, D336, D337, D342, D342C, D343, D348, D353C, D364, D375D, D379, D379A, D397D, D398, D399, G343, G353D, G379
5L6435 CONTACTOR (Water Temperature)
3192, 3208, 3304, 3306, 3406, 3408, 3512, 7231, 7241, 7271, 977K, 983, D250B, D25C, D300B, D30C, D320A, D330A, D333A, D334, D336, D342, D342C, D343, D348, D350C, D353C, D35C, D35HP, D379, D379A, D398,...
4L8264 CONTACTOR
D326F, D342, D342C, D343
1L5099 CONTACTOR
D320A, D342, D342C, D343, D353C, D379, D398
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.