AVSPARE.COM
parts catalog

CONVERSION AR-MACHINE 3156353 - Caterpillar



3156353 CONVERSION AR-MACHINE Caterpillar parts 246C, 262C2 CONVERSION
Rating:
77
Alternative (cross code) number:
CA3156353
315-6353
3156353
Caterpillar 3156353 CONVERSION AR-MACHINE

Buy CONVERSION AR-MACHINE 3156353 Caterpillar genuine, new aftermarket tractor parts with delivery
SKID STEER LOADER,

Compatible equipment models: 3156353:

SKID STEER LOADER  246C   262C2   Caterpillar
  For full view, you need register

Information:


Improper lubrication can cause damage to machine components.To avoid damage, make sure that the proper amount of grease is applied to the swing drive.When the amount of grease in the compartment becomes too large, the agitation loss becomes large, thereby accelerating grease deterioration.Grease deterioration can cause damage to the pinion gear of the swing drive and swing internal gear. Not enough grease will result in poor gear lubrication.
Illustration 1 g00834990Remove the inspection cover that is located near the boom base. Inspect the grease.
Illustration 2 g00688056
Remove bolts (1) and washers (2). Remove cover (3) and gasket (4).
Illustration 3 g00115464
Inspect gasket (4). Replace the gasket if damage is evident.
Check the level of the grease. The grease should be evenly distributed on the floor of the pan.Refer to Operation and Maintenance Manual, "Capacities (Refill)" for the capacity of the swing gear.Add grease, as needed. Remove grease, as needed. Too much grease will result in the deterioration of the grease that is caused by excessive movement of the grease. Too little grease will result in poor lubrication of the swing gear.
Illustration 4 g00101653
Check for contamination and for discolored grease.
If the grease is contaminated or discolored with water, change the grease. Remove plug (5) in order to allow the water to drain. When you reinstall plug (5), inspect O-ring seal (6). Replace the O-ring seal if damage is evident.
Lower the bucket to the ground.
Repeat Step 6 at every 90 degrees in 4 places. Add grease, as needed.

Caterpillar SIS machinery equipment:

Caterpillar SIS


Parts conversion Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.