COUNTERWEIGHT & MOUNTING GP 3967726 - Caterpillar

Settings Menu
Illustration 8 g02175803The "Settings" menu option is accessed from the "Home" menu. Press the up arrow button or the down arrow button until "Settings" is highlighted. Then press the "OK" button.Operating conditions, preferences of the operator and requirements for operating efficiency dictate the need to adjust the parameters.The "Display Setup", "Machine", "Chassis", "Brake", "VIMS", "Engine" and "Auto Lube" selections that are available in the "Settings" menu can be password protected with the "Service Mode" password in order to limit access to programmable parameters. The programmed parameters in the password protected menu options are available for viewing only. Cat ET must be used in order to set the password.
Table 4
Settings Menu
Display Setup(1) Language
Units ("English" or "Metric")
Contrast
Headlights on dimming(2)
Headlights off dimming(3)
Date format
Time format
Engine EIS (Engine Idle Shutdown) Delay Time
EIS Enable Start
EIS Max Air Temp
EIS Min Air Temp
Ether Solenoid None
Continuous Flow
Machine Product identification
Machine identification
Chassis Autolube Duration
Body Up Speed Limit
Economy Mode Percent
Load Count - Body (only visible without VIMS)
Machine Loaded Speed Limit
Max Fwd Speed Limit
Max Rev Speed Limit
Second Gear Start
Sound Reduction Engine Speed
Sound Reduction Test Mode
Top Gear Limit
Brake Desired engine retarding speed
VIMS Payload Target Weight
Overload Limit
Last Pass Status
Conditional Logger (Password Protected)
(1) Individual preferences for the "Display Setup" need to be saved in the operator profile. If the profile is set to "Factory Set", the preferences will revert to the default setting when the keyswitch is turned OFF. In order to save a preference, a profile must be selected or created.
(2) Headlights on dimming will adjust the setting of the backlight for the display screen. This setting will determine the backlight intensity that will be used when the headlights are on.
(3) Headlights off dimming will adjust the setting of the backlight for the display screen. This setting will determine the backlight intensity that will be used when the headlights are off.Service Mode Menu
Illustration 9 g02175804The "Service Mode" menu option is accessed from the "Home" menu. Press the up arrow button or the down arrow button until "Service Mode" is highlighted. Then press the "OK" button.The "Service Mode" menu is used in order to access the password protected menu options. The "Service Mode" protects certain features from access by the operator. Features that are protected from the operator can be enabled or disabled with a password.Note: A password may be required or a password may not be required. This depends on the settings that have been made in Cat ET.A Service Tool must be used to program the password into the display. The password cannot be changed within the Advisor.