AVSPARE.COM
parts catalog

COUPLER GP-QUICK 3967204 - Caterpillar



3967204 COUPLER GP-QUICK Caterpillar parts 272D, 272D XHP, 299D, 299D XHP COUPLER
Rating:
33
Alternative (cross code) number:
CA3967204
396-7204
3967204
Caterpillar 3967204 COUPLER GP-QUICK

Buy COUPLER GP-QUICK 3967204 Caterpillar genuine, new aftermarket tractor parts with delivery
COMPACT TRACK LOADER, SKID STEER LOADER,

Compatible equipment models: 3967204:

COMPACT TRACK LOADER  299D   299D XHP  
SKID STEER LOADER  272D   272D XHP   Caterpillar
Number on catalog scheme:
 
  For full view, you need register

Information:


Illustration 1 g01125630
Schematic of the Implement Lockout Solenoid
This diagnostic code is associated with the Implement Lockout Solenoid. The FMI 05 means that the ECM has determined that the current of the solenoid is below normal. The possible causes of this diagnostic code are listed below:
The energize circuit of the solenoid is open.
The return circuit of the solenoid is open.
The solenoid has failed.
The ECM has failed. This is unlikely. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 882 FMI 05 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.Test Step 1. CHECK THE SOLENOID.
Turn the disconnect switch and the key start switch to the ON position. Do not start the engine.
Disconnect the solenoid with the active diagnostic code from the machine harness.
At the machine harness connector for the solenoid, place a jumper wire from the contact for G962-OR(Orange) to the contact for H807-YL(Yellow).
Observe the status of the CID 882 FMI 05. Expected Result:The CID 882 FMI 05 remains active. The FMI has not changed and the "05" is still active.Results:
YES - The diagnostic code remains active. The jumper wire does not affect the diagnostic code. Proceed to Test Step 2.
NO - The diagnostic is no longer active. The solenoid has failed.Repair: The solenoid has failed. Repeat this Test Step "CHECK THE SOLENOID" in order to verify the solenoid failure. Replace the solenoid. Verify that the new solenoid corrects the problem.STOPTest Step 2. CHECK THE HARNESS FOR AN OPEN.
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness connector(s) from the ECM.
The jumper wire that was installed in the previous Test Step remains in place.
At the machine harness connector, measure the resistance from signal contact J2-2 (wire G962-OR(Orange)) to contact J2-4 (wire H807-YL(Yellow)). Expected Result:The resistance is less than 5.0 ohms.Results:
OK - The resistance is less than 5.0 ohms. The machine harness is correct. Proceed to Test Step 3.
NOT OK - The resistance is greater than 5000 ohms. The resistance measurement is not correct. There is an open circuit in the machine harness.Repair: The open is in wire G962-OR(Orange) or in wire H807-YL(Yellow) of the machine harness. Repair the machine harness or replace the machine harness.STOPTest Step 3. CHECK IF THE DIAGNOSTIC CODE REMAINS.
Inspect the contacts of the harness connectors and clean the harness connectors.
Reconnect all harness connectors.
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Check the status of the CID 882 FMI 05. Expected Result:The CID 882 FMI 05 is active. Results:
YES - The CID 882 FMI 05 is active. The diagnostic code has not been corrected. The ECM may have failed.Repair: It is unlikely that the ECM has failed. Exit this procedure and perform this procedure again. If the cause of the diagnostic code is not found, replace the ECM. See

Caterpillar SIS machinery equipment:

Caterpillar SIS

Caterpillar parts catalog:

Caterpillar parts catalog
299D XHP Compact Track Loader NLC00001-UP (MACHINE)
299D Compact Track Loader HCL00001-UP (MACHINE)
272D XHP Skid Steer Loader SHY00001-UP (MACHINE) POWERED BY C3.8 Engine
272D Skid Steer Loader GSL00001-UP (MACHINE)


Parts coupler Caterpillar catalog:

3454910 COUPLER AR-QUICK
246D, 262D, 272D, 272D XHP, 277D, 279D, 287D, 289D, 299D, 299D XHP
3454911 COUPLER AR-QUICK
272D, 272D XHP, 299D, 299D XHP
3455001 COUPLER GP-QUICK
246D, 262D, 272D, 272D XHP, 277D, 279D, 287D, 289D, 299D, 299D XHP
1645567 COUPLER AS-QUICK DISCONNECT
1090, 1190, 1190T, 1290T, 216, 216B, 216B3, 226B, 226B3, 228, 232B, 236, 236B, 236B3, 236D, 242B, 242B3, 242D, 246C, 246D, 247, 247B, 247B3, 248, 252B, 252B3, 256C, 257B, 257B3, 257D, 259B3, 259D, 262...
1857887 COUPLER AS-QUICK DISCONNECT
216, 216B, 216B3, 226B, 226B3, 228, 232B, 236, 236B, 236B3, 236D, 242B, 242B3, 242D, 246C, 246D, 247, 247B, 247B3, 248, 252B, 252B3, 256C, 257B, 257B3, 257D, 259B3, 259D, 262C, 262C2, 267, 267B, 268B,...
4216171 COUPLER AS-QUICK DISCONNECT
216, 216B, 216B3, 226B, 226B3, 228, 232B, 236, 236B, 236B3, 236D, 242B, 242B3, 242D, 246C, 246D, 247, 247B, 247B3, 248, 252B, 252B3, 256C, 257B, 257B3, 257D, 259B3, 259D, 262C, 262C2, 262D, 267, 267B,...
3474432 COUPLER-QUICK DISCONNECT
232B, 236B, 236B3, 242B, 242B3, 246C, 247B, 252B, 252B3, 256C, 257B, 257B3, 259B3, 262C, 262C2, 267B, 272C, 272D XHP, 277C, 277C2, 279C, 279C2, 287C, 287C2, 289C, 289C2, 297C, 299C, 299D XHP
3474431 COUPLER-QUICK DISCONNECT
232B, 236B, 236B3, 242B, 242B3, 246C, 247B, 252B, 252B3, 256C, 257B, 257B3, 259B3, 262C, 262C2, 267B, 272C, 272D XHP, 277C, 277C2, 279C, 279C2, 287C, 287C2, 289C, 289C2, 297C, 299C, 299D XHP
3856394 COUPLER AS
216B3, 226B3, 236B3, 236D, 242B3, 242D, 246C, 246D, 247B3, 252B3, 256C, 257B3, 257D, 259B3, 259D, 262C, 262C2, 262D, 272C, 272D, 272D XHP, 277C, 277C2, 277D, 279C, 279C2, 279D, 287C, 287C2, 287D, 289C...
4233676 COUPLER AS
246D, 262D, 272D, 272D XHP, 277D, 279D, 287D, 289D, 299D, 299D XHP
1938526 COUPLER AR-QUICK
966G, 966G II, 966H, 972G, 972G II, 972H, PW2503/7
3912705 COUPLER AS-QUICK
324D L, 324D LN, 325D L, 329D L, 329D LN, 329E L, 329E LN, 330D L, 336D L, 336D LN, 336E LN
2837431 COUPLER AR-QUICK
323D L, 323D2 L, 324D, 324D L, 324D LN, 325D L, 329D L, 329D LN, 329E LN, CW-10
2409582 COUPLER GP-QUICK
365B II, 365C, 365C L, 365C L MH, 385B, 385C, 385C L, 385C L MH
1941519 COUPLER GP-QUICK
950G, 950G II, 962G, 962G II
1728476 COUPLER GP-QUICK
311C, 312C L, 314C, PIN GRAB
2404043 COUPLER GP-QUICK
301.4C, 301.5, 301.6C, 301.7D, 301.7D CR
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.