AVSPARE.COM
parts catalog

COUPLING, FLEX 1C4111 - Caterpillar



1C4111 COUPLING, FLEX Caterpillar parts COUPLING
Rating:
21
Alternative (cross code) number:
CA1C4111
1C-4111
1C4111
Caterpillar 1C4111 COUPLING, FLEX
Weight: 9 pounds 4 kg.

Buy COUPLING, FLEX 1C4111 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Typical Example1. Remove bolts (1) and cover (2). Remove bolts (3) and cover (4).
Typical Example2. Remove bolts (5) and adapter (6). Be sure that gear stays in place. Remove bolts (7) and cover (8). Keep gear in place.
Typical Example3. Remove gears (9) and crankshaft gear (10). Remove bolts (11) and idler gear (12) with retainer. Remove bolts (13) and idler gear (14) with retainer.
Typical Example4. Secure a strap and a hoist to flywheel housing (15). Remove hose assembly (16) and small bolts (17) and large bolts (18). 5. Remove bolts (19) that connect the flywheel housing to oil pan (20). Remove the flywheel housing from the cylinder block. The weight of the flywheel housing is approximately 105 kg (230 lb). 6. Check O-ring seal (21) and bearing (22) on the adapter and replace if necessary. 7. Check bearing (23) and O-ring seal (24) on the cover and replace if necessary. 8. Remove retainers (25) from gears (9) and check bearings (26) and replace if necessary. The following steps are for the installation of the flywheel housing. 9. Thoroughly clean the contact surfaces of the cylinder block and flywheel housing. Apply approximately 13 mlof 1U-8846 Gasket Makeras a continuous film on entire joint face. Install a new gasket between the flywheel housing and the cylinder block. 10. Secure a strap and a hoist to the flywheel housing, put the flywheel housing in position on the cylinder block. 11. Install the bolts that hold the flywheel housing to the cylinder block. Tighten bolts 1 thru 22 in number sequence to a torque of 40 10 N m (30 7 lb ft).Tighten bolts 1 thru 9 in number sequence again to a torque of 135 20 N m (100 15 lb ft).Tighten bolts 10 thru 22 in number sequence again to a torque of 55 10 N m (40 7 lb ft).12. Install bolts that connect housing to oil pan.13. Cut flywheel housing gasket off even with the cylinder block surface. Remove excess sealant.14. Install bolts (19) that connect oil pan (20) to the housing. 15. Install idler gear (14) and retainer with bolts (13). Install idler gear (12) and retainer with bolts (11). Install crankshaft gear (10) and gears (9). 16. Install cover (8) and bolts (7). Install adapter (6) and bolts (5). 17. Install cover (4) and bolts (3). Install cover (2) and bolts (1).End By:a. install crankshaft rear seal and wear sleeve


Parts coupling Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.