AVSPARE.COM
parts catalog

COVER 3534663 - Caterpillar



3534663 COVER Caterpillar parts COVER
Rating:
21
Alternative (cross code) number:
CA3534663
353-4663
3534663
Caterpillar 3534663 COVER
Weight: 1 pounds 0 kg.

Buy COVER 3534663 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Illustration 1 g03895654Open the cover of the storage box that is located on the right side in front of the fuel tank.The electric refueling pump (1) pumps fuel into the fuel tank.
Do not continuously operate the refueling pump for more than 30 minutes. Do not operate the refueling pump more than a few seconds without fuel. Pump damage can result.
On - Push switch (3) in order to activate the refueling pump.
Off - Push switch (4) in order to deactivate the refueling pump.
Remove cap (2) from the fuel tank.
Illustration 2 g03895673
Foot Valve Assembly
Open the end cap (6) of the foot valve (5) and make sure the rubber seal (7) is fixed at bottom of the end cap.
Properly insert the foot valve (5) into a container of fuel.
Push switch (3) in order to supply the fuel to the tank. When the tank is full, the pump stops refueling.
If the fuel is not pumped smoothly, check and clean the strainer filter (8) of the foot valve.
Illustration 3 g03895855
Half open the cap (6) and pull an end of the spring clip (9) with needle-nose pliers to remove the spring clip from the cap. Note: The spring clip cannot be removed with the cap opened fully.
Remove the cap (6) from the foot valve.
Illustration 4 g03895880
Remove spring clip (10) from the foot valve. Note: Be careful not to damage the end face of the foot valve.
Remove the strainer (8) from the foot valve.
Clean up the strainer.
Reinstall the strainer (8) into the foot valve.
Reinstall the spring clip (10) on the groove of the foot valve to fix the strainer.
Illustration 5 g03896402
Install cap (6) and close halfway.
Install spring clip (9) on the groove inside the cap.
After refueling, install cap (2) to the fuel tank.
Make sure that excess fuel is drained from suction hose before storing the suction hose.
Fully close the end cap of the foot valve (5) without any dirt on the seal of the end cap
When storing the suction hose, wind the hose on the bar. Secure the foot valve (5) in place. Note: To prevent hose damage, do not coil the hose in a tight radius.
Close the cover of the storage box.


Parts cover Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.