AVSPARE.COM
parts catalog

CRADLE 1C4042 - Caterpillar



1C4042 CRADLE Caterpillar parts PR-1000, PR-450C, PR-750B CRADLE
Rating:
52
Alternative (cross code) number:
CA1C4042
1C-4042
1C4042
Caterpillar 1C4042 CRADLE
Weight: 8 pounds 3 kg.

Buy CRADLE 1C4042 Caterpillar genuine, new aftermarket tractor parts with delivery
COLD PLANER,

Compatible equipment models: 1C4042:

COLD PLANER  PR-1000   PR-450C   PR-750B   Caterpillar
Number on catalog scheme: 2
 
  For full view, you need register

Information:

Communication will not occur when power to the PL522 or 523 is below 10.5 VDC. The PL522 or 523 will still communicate with Caterpillar Electronic Technician (Cat ET ) when power to the module is down to 9 VDC. A diagnostic code of "CID 168 FMI 01" will occur when the system voltage drops below 11 VDC. A diagnostic code of "CID 254 FMI 04" will occur when the system voltage drops below 9 VDC. This CID code is logged so that no messages will be communicated from the machine to the office.Test Step 1. CHECK THE SYSTEM VOLTAGE AT THE PL522 and 523.
Start the engine and operate the engine at a high idle for 5 to 10 minutes.
Measure the system voltage between the "Unswitched Power" and the "Ground" contacts. Pin 52 is the terminal for "Unswitched Power" and pin 65 is the terminal for "Ground". Expected Result:The voltage is 11 VDC to 32 VDC.Results:
OK - The voltage is 11 VDC to 32 VDC. The PL522 and 523 should not be logging this diagnostic code.Repair: Use Cat ET in order to clear the diagnostic code from the PL522 and 523. If the voltage is correct and the PL522 and 523 records the diagnostic code again, Replace the PL522 and 523. Before replacing the PL522 and 523, contact your Caterpillar Technical Communicator.STOP
NOT OK - The voltage is not 11 VDC to 32 VDC. Proceed to Test Step 2.Test Step 2. CHECK THE ALTERNATOR.
Run the engine at high idle for 5 to 10 minutes.
Measure the voltage output at the battery posts. Expected Result:The voltage should be below 32 VDC.Results:
OK - The voltage is below 32 VDC. The battery could be faulty. Proceed to Test Step 3.
NOT OK - The voltage is above 32 VDC. Repair the alternator or replace the alternator. The voltage regulator could be faulty. If conditions are not resolved, proceed to Test Step 3.Test Step 3. CHECK THE BATTERY VOLTAGE.Turn the keyswitch to the OFF position. Measure the battery voltage at the battery posts.Expected Result:The voltage should be below 32 VDC.Results:
OK - The voltage is below 32 VDC. Proceed to Test Step 4.
NOT OK - The voltage is above 32 VDC. Repair: See Special Instruction, REHS0354, "Charging System Troubleshooting".If conditions are not resolved, proceed to Test Step 4.Test Step 4. CHECK EVERY ECM ON THE MACHINE.Check the logged diagnostics of any other ECM that is installed on the machine. Compare each ECM that has logged the"CID 168 FMI 00" code in the same time period. The Diagnostic Clock Hours (DCH) on the logs may be different. The difference between the current DCH and the logged DCH is important.Expected Result:Other "CID 168 FMI 00" diagnostic codes can be found on other Electronic Control Modules (ECM).Results:
YES - "CID 168 FMI 00" diagnostic codes are found on other Electronic Control Modules (ECM).Repair: Clear the fault if all the following conditions occur:
A problem is not found with the charging system.
A problem is not found with the wiring.
The fault has occurred a

Caterpillar parts catalog:

Caterpillar parts catalog
PR-1000C Cold Planer 5XC00138-UP (MACHINE) POWERED BY 3208 Engine
PR-450C Cold Planer 7PJ00001-UP (MACHINE) POWERED BY 3408 Engine


Parts cradle Caterpillar catalog:

1453771 CRADLE
365C, 365C L, 365C L MH, 374D L, 550, 550B, 560B, 570, 570B, 580, 580B, 844, 844H, 844K, 990 II, 990H, 993K, M320, M322C, M322D, M322D MH
1393274 CRADLE
572R, 574, D7R
1358051 CRADLE-BEARING
PF-290B, PS-150B, PS-150C, PS-200B, PS-360B, PS-360C
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.