AVSPARE.COM
parts catalog

DISTRIBUTION 3534574 - Caterpillar



3534574 DISTRIBUTION Caterpillar parts DISTRIBUTION
Rating:
41
Alternative (cross code) number:
CA3534574
353-4574
3534574
Caterpillar 3534574 DISTRIBUTION

Buy DISTRIBUTION 3534574 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Specification
Table 1
"Swing Speed and Overswing on Level Ground - Check"
Item New Service Limit Actual
Swing Speed (three Revolutions) (seconds)
Right Swing 21.4 1.0 27.8 or less
Left Swing
Swing Acceleration on Level Ground (seconds)
Right Swing 5.3 or less 6.9 or less
Left Swing
Overswing mm (inch)
Right Swing 1200 mm (47.2 inch) or less 1200 mm (47.2 inch) or less
Left Swing Introduction
Measuring the swing speed and the overswing of the machine will determine if there is a need to check the swing motor. The fine swing control switch (if equipped) must be in the OFF position.Note: The engine speed and/or the machine configuration that is used during this test can affect the results of this test. Refer to Testing and Adjusting, "Engine Performance - Test (Engine Speed)" for the engine speed that was used for this test. Refer to Testing and Adjusting, "Operational Checks" for the machine configurations that were used for this test.Note: The relief valve pressure settings must be set to the relief valve pressure specification before performing this operational check. Refer to Testing and Adjusting, "Specifications".Required Tools
Table 2
Required Tools
Description Qty
Measuring Tape 1
Stopwatch 1 Test Procedure
Swing Speed (three revolutions)
Illustration 1 g00297618
Position the machine on level ground. Refer to Illustration 1. Note: The bucket should be empty.
Swing the machine in either direction. Use a stopwatch to count the swing time for three revolutions. Note: Begin counting swing time after one full revolution has been completed.Swing Acceleration and Overswing
Illustration 2 g00297618
Position the machine on level ground. Refer to Illustration 1. Note: The bucket should be empty.
Stop the engine.
Illustration 3 g00293972
(A) Upper frame
(B) Undercarriage frame
(C) Marking
To indicate the relationship of the two positions, put a mark (C) on the inner race and the outer race of the swing bearing. The mark will be used as a target to stop the swing operation. Refer to Illustration 3.
Start the engine.
Move the swing joystick in either direction until the machine completes a 180 degree swing operation away from the target.
Move the swing joystick in either direction until the machine completes a 180 degree swing operation toward the target. Return the swing joystick to the NEUTRAL position at the target.
Measure the amount of overswing by measuring the distance between the marks on the swing bearing. Refer to Illustration 3. Note: Use a point that is visible from the operator seat as a reference point for the target.


Parts distribution Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.