EDGE-CUTTING 4416624 - Caterpillar

(1) Apply 9S-3263 Sealant on threads of bolts.(2) Apply 9S-3263 Sealant on threads of bolts and torque 20 bolts to ... 530 70 N (395 50 lb ft)(3) Apply 1U-8846 Gasket Maker on both surfaces of ring gear which contact cover and housing.(4) Make stake marks near opening of each pin hole after installation.(5) Apply 9S-3263 Sealant on threads of bolts and torque 16 bolts to ... 570 79 N m (420 60 lb ft)(6) O-rings of floating seal and all surfaces in contact with them must be clean and dry at assembly. Apply a thin layer of oil on the surfaces that make contact on the metal seals before installation.(7) Use plate to adjust end play (A) ... 1.0 to 2.0 mm (.04 to .08 in)(8) Apply 5P-3931 Anti-Seize Compound to the bores of pins.(10) Use shim to adjust bearing preload to ... 0.50 to 0.10 mm (.020 to .040 in)(11) Apply 5P-3931 Anti-Seize Compound to all surfaces that make contact with bearings.(11) Preload on bearing:Make an adjustment as follows.1. Put a load (P), of 4000 kg (8800 lbs) on bearing (11).2. Rotate housing (12) to seat the bearing.3. Reduce the load to 1000 100 kg (2220 220 lbs) and measure distance (C).4. Measure distance (D) of gear (9).5. Use a maximum of two shims (10) as required.The total shim thickness must be: [(C) - (D)] 0.05 mm ( .002 in).