AVSPARE.COM
parts catalog

EDGE 4Z9129 - Caterpillar



4Z9129 EDGE Caterpillar parts EDGE
Rating:
21
Alternative (cross code) number:
CA4Z9129
4Z-9129
4Z9129
Caterpillar 4Z9129 EDGE
Weight: 1294 pounds 586 kg.

Buy EDGE 4Z9129 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1P-0074 Slide Hammer 1
135-0482 Adapter 1
B 1U-8233 Nylon Lifting Sling 1 Start By:
Release the system pressure.
At operating temperature, the hydraulic tank is hot and under pressure.Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin.Remove the filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. Remove the filler cap slowly in order to relieve pressure.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g00513819
The weight of the hoist cylinder is approximately 154 kg (340 lb). Use Tooling (B) in order to attach an appropriate hoist to the hoist cylinder. Remove grease fitting (1). Remove bolt (2) and the washer from the dump body.
Illustration 2 g00513919
Use Tooling (A) to remove pin (3) from the dump body.
Illustration 3 g00513922
Loosen two retaining nuts (4) and disconnect two hose assemblies (5) from the hoist cylinder.
Illustration 4 g00513925
Remove two bolts (6) and the washers that secure hoist cylinder (7) to the frame. Remove hoist cylinder (7) with Tooling (B). Note: Spacer plates may be installed between the rear frame and the mount for the hoist cylinder. Note the location of the spacer plate for installation purposes.Installation Procedure
Install hoist cylinder (7) in the reverse order of removal.


Parts edge Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.