AVSPARE.COM
parts catalog

ELBOW, 90DEG 1 1C4236 - Caterpillar



1C4236 ELBOW, 90DEG 1 Caterpillar parts ELBOW
Rating:
26
Alternative (cross code) number:
CA1C4236
1C-4236
1C4236
Caterpillar 1C4236 ELBOW, 90DEG 1
Weight: 3 pounds 1 kg.

Buy ELBOW, 90DEG 1 1C4236 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

(1) Torque for six nuts (three each side) ... 19 2 N m (14 1.5 lb ft)Pilot Control Valves (Standard)
Apply sealant to threads and torque bolt (4) to ... 15 N m (10 lb ft)(5) Torque for bolts ... 5.5 N m (4.0 lb ft)(6) Torque for two cartridges ... 45 N m (30 lb ft)When the pilot valve is in the fully stroked position, gap (8) between plate (2) and the spool not being stroked should be 0.13 to 0.75 mm (.005 to .030 in). Loosen nuts (1) and (7) and adjust as necessary.Apply sealant to top three threads of bolt (3) and torque nut (1) to ... 100 N m (75 lb ft) 107-9089 IT28G tilt valve is shown, however, all other standard pilot control valves have the same torque and spool gap adjustment specifications.Multifunction Pilot Control Valves (Optional)
107-9597 - 928G; 107-9598 - IT28G
(3) Torque for two bolts (one partially shown) ... 20 N m (15 lb ft)(6) Torque for four capsule assemblies ... 45 N m (33 lb ft)Tighten pivot plate (2) until it contacts all four plungers (4) while the plungers are in the hold position. Loosen pivot plate (2) one-eighth turn and lock in place by tightening nut (1) to a torque of 65 N m (50 lb ft).Apply thread sealant to pivot bolt (5) and torque to ... 10 N m (7 lb ft)Auxiliary Pilot Control Valves
107-9090 - (With Standard Valves); 108-3927 - (With Multifunction Valves)
Apply sealant to top three threads of bolt (3) and torque nut (1) to ... 100 N m (75 lb ft)Apply sealant to threads and torque bolt (4) to ... 15 N m (10 lb ft)(5) Torque for bolts ... 5.5 N m (4.0 lb ft)(6) Torque for two cartridges ... 45 N m (30 lb ft)When the pilot valve is in the fully stroked position, gap (8) between plate (2) and the spool not being stroked should be 0.13 to 0.75 mm (.005 to .030 in). Loosen nuts (1) and (7) and adjust as necessary.


Parts elbow Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.