AVSPARE.COM
parts catalog

ELECTRICAL AR 4646008 - Caterpillar



4646008 ELECTRICAL AR Caterpillar parts ELECTRICAL
Rating:
46
Alternative (cross code) number:
CA4646008
464-6008
4646008
Caterpillar 4646008 ELECTRICAL AR

Buy ELECTRICAL AR 4646008 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Once the system is placed in automatic mode, blade movement may occur.Ensure that all personnel are clear of the blade before you place the system in automatic mode.Personal injury or death from crushing could occur.
When the blade movement stops, switch the system back into manual mode.Note: Do Not Move The Blade.
Place blocks under the blade before checking the blade level.
Illustration 1 g01022095
Use a level in order to check that the cutting edge of the blade is level.
If the blade is not level, determine if the left side of the blade is high or low.
Enter the "Configuration" menu.
Press the Arrow Keys until "Linked Elevation Adjustment" is highlighted on the display.
Illustration 2 g01302509
Press the "OK/right reset" key in order to enter the "Linked Elevation Adjustment" menu. A screen that is similar to Illustration 2 appears.Note: The number is always zero when you enter this screen. The maximum value that may be added to the screen is plus 0.1 or minus 0.1.
Enter a positive value in order to lift the left side of the blade. Enter a negative value in order to lower the left side of the blade.Use the steps that are outlined below:
Press the "increment" key in order to move the cursor to the right. Highlight the digit that you wish to change. Do one of the following:
Press the Arrow Keys UP in order to increase the elevation offset adjustment to the required value.
Press the Arrow Keys DOWN in order to decrease the elevation offset adjustment to the required value.Accept the change or cancel the change by doing one of the following:
Press the "OK/right reset" key in order to save the changes and exit to the "Configuration" menu.
Press the "ESC/left reset" key in order to cancel the changes and exit to the "Configuration" menu.


Parts electrical Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.