ENGINE AR-COMPLETE 1695101 - Caterpillar

Install lip seal (27).
Illustration 25 g03131679
Illustration 26 g03131677
Position mount (21) and hitch (22). Install pin (17) and bolts (16).
Install pin assembly (19).
Use center bolt (16A) to pull pins (17) and (19) together.
Illustration 27 g03172276
Measure the gap at (X1) and (X2), record as Dimension (V). Divide Dimension (V) by 2. Record the average gap as Dimension (U). The required shim thickness is (Dimension (U) + 0.00 - 0.20 mm (+ 0.000 - 0.008 inch)).
Illustration 28 g03131772
Install shims (20) and pin assembly (19). Install bolts (18) and bolt (16A).
Illustration 29 g03129882
Install sensor assembly (14) and bolts (15).
Illustration 30 g03131780Note: Graphic for reference only.
Use a suitable lifting device, Tooling (C) and Tooling (D) to position articulating hitch (9). The weight of articulating hitch (9) is approximately 340 kg (750 lb). Place suitable cribbing in articulating hitch (9) to prevent rotation.
Illustration 31 g03129856
Install bolts (13).
Illustration 32 g03129636
Connect harness assembly (12).
Illustration 33 g03129604
Secure Tooling (B) to articulating hitch (9). Position rear frame (10) as shown.
Illustration 34 g03129616
Install bolts (11). Tighten bolts (11) evenly in order to keep an even gap on the right and left side of articulating hitch (9). A gap will exist on each side of articulation hitch (9) and rear frame (10).
Illustration 35 g03129602
Connect harness assemblies (8).
Illustration 36 g02902416
Install bracket assembly (5).
Connect harness assembly (6) and hose assemblies (7).
Repeat Steps 18 through 19to the other side of machine.
Illustration 37 g03129600
Connect clip (4).
Connect hose assembly (3).
Illustration 38 g03129589
Install clip (1) and clamp (2).
Refer to Operation and Maintenance Manual, "Hydraulic System Oil - Change" for draining and filling procedures. End By:
Install water pump.
Install steering cylinder.
Install water tank.
Install engine support.