1695180 ENGINE AR-COMPLETE Caterpillar parts 3406E ENGINE
Rating:
Alternative (cross code) number:
CA1695180
169-5180
1695180
CA1695180
169-5180
1695180
TRUCK ENGINE,
Compatible equipment models: 1695180:
TRUCK ENGINE 3406E
Caterpillar
For full view, you need register
Information:
Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Loctite 242 1
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Cylinders equipped with lock valves can remain pressurized for very long periods of time, even with the hoses removed.Failure to relieve pressure before removing a lock valve or disassembling a cylinder can result in personal injury or death.Ensure all pressure is relieved before removing a lock valve or disassembling a cylinder.
Illustration 1 g02905761
Use a suitable lifting device to remove cutter assembly (2), not shown. The weight of cutter assembly (2) is approximately 60 kg (133 lb).
Remove hose assemblies (3).
Remove bolts (6) and clamp (7).
Remove bolts (1) and cutter assembly (2).
Loosen clamp bolt (5) and remove roller (4). Installation Procedure
Install cutter assembly (2) in the reverse order of removal.
Apply Tooling (A) to bolts (1).
Tighten clamp bolt (5) to a torque of 160 20 N m (118 15 lb ft).
Adjust spray water to center of roller (4) taper. Tighten bolts (6) to a torque of 6 1 N m (53 9 lb in).
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Loctite 242 1
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Cylinders equipped with lock valves can remain pressurized for very long periods of time, even with the hoses removed.Failure to relieve pressure before removing a lock valve or disassembling a cylinder can result in personal injury or death.Ensure all pressure is relieved before removing a lock valve or disassembling a cylinder.
Illustration 1 g02905761
Use a suitable lifting device to remove cutter assembly (2), not shown. The weight of cutter assembly (2) is approximately 60 kg (133 lb).
Remove hose assemblies (3).
Remove bolts (6) and clamp (7).
Remove bolts (1) and cutter assembly (2).
Loosen clamp bolt (5) and remove roller (4). Installation Procedure
Install cutter assembly (2) in the reverse order of removal.
Apply Tooling (A) to bolts (1).
Tighten clamp bolt (5) to a torque of 160 20 N m (118 15 lb ft).
Adjust spray water to center of roller (4) taper. Tighten bolts (6) to a torque of 6 1 N m (53 9 lb in).
Caterpillar SIS machinery equipment:
Caterpillar SIS
- 3406E Truck Engine 2WS00001-UP » 169-5180 ENGINE AR-COMPLETE