ENGINE AR-COMPLETE 2142903 - Caterpillar

Illustration 1 g02067293
Left rear viewTypical example (1) As required, use the following shims until the centerline of front and rear roller assemblies are within 2.0 mm ( 0.08 inch) of the center line of the drive wheel. 190-2479 Shim Thickness of one shim ... 1.50 mm (0.059 inch) 190-2478 Shim Thickness of one shim ... 3.00 mm (0.118 inch) 190-2477 Shim Thickness of one shim ... 6.35 mm (0.250 inch) (2) As required, use the following shims until the centerline of front and rear roller assemblies are within 2.0 mm ( 0.08 inch) of the center line of the drive wheel. 190-2489 Shim Thickness of one shim ... 0.45 mm (0.018 inch) 190-2488 Shim Thickness of one shim ... 1.50 mm (0.059 inch) 190-2487 Shim Thickness of one shim ... 3.00 mm (0.118 inch) 190-2486 Shim Thickness of one shim ... 6.35 mm (0.250 inch) (3) Torque for the bolt ... 1350 50 N m (996 37 lb ft) (4) Torque for bolts ... 900 100 N m (664 74 lb ft) (5) Install the plate to the face of the shaft. As required, add the shims between the plate and the frame until the gap is within 0.5 mm (0.02 inch).
Illustration 2 g02067314
(6) Apply 4C-4030 Thread Lock Compound to the threads of two screws. (7) Use grease fittings in order to pack the bearings with 5P-0960 Grease Cartridge. Then replace the grease fittings with the pipe plugs. (8) Allow 6.0 2.0 mm (0.24 0.08 inch) of the rod thread to protrude past the nut. (9) Torque for the nut ... 340 50 N m (251 37 lb ft) (10) Torque for two nuts ... 237 50 N m (175 37 lb ft) (11) Before assembly, apply 4C-5599 Anti-Seize Compound to the cylindrical surface that are in contact with the pin. (12) Torque for the bolt ... 271 50 N m (200 37 lb ft) (13) Apply 5P-0960 Grease Cartridge through the grease fitting until the grease is visible on both sides of the bearing. (14) Install the lip type seals, so that the lip of the lip type seal faces outward.Note: Freeze the sleeve bearing to −65 °C (−85 °F) prior to installation. Apply 5P-0960 Grease Cartridge to the inside surfaces of the sleeve bearing. (15) 206-2615 Sleeve Bearing Inside diameter ... 50.845 0.020 mm (2.0018 0.0008 inch) Outside diameter ... 63.564 0.013 mm (2.5025 0.0005 inch) Installation depth of the sleeve bearing ... 10.5 1.0 mm (0.41 0.04 inch)